478500
44
Verklein
Vergroot
Pagina terug
1/76
Pagina verder
Page 42 FT-897D OPERATING MANUAL
ATAS-100/-120 Operating Tips
The information below will help you derive the best perfor-
mance possible from the ATAS-100/-120 Active-Tuning An-
tenna System.
Grounding
It is critically important that you establish a good mechani-
cal and RF ground connection for your ATAS-100/-120 (as
with all vertical antennas). Mobile mounts which are bolted
through the vehicle’s roof, or otherwise mechanically af-
fixed, will usually be satisfactory. However, magnetic mounts
do not provide the RF grounding necessary for good perfor-
mance, and are not recommended for use with this antenna.
Tuning Procedure
The feedpoint impedance of the ATAS-100/-120 (resistance
and reactance) will necessarily vary over a wide range when
you change bands. Occasionally, the transceiver’s micro-
processor will not initially be able to determine the proper
direction for the ATAS-100/-120 to travel (inward or out-
ward) for best SWR.
To resolve this situation, the transceiver will then command
the ATAS-100/-120 to retract fully to its minimum height,
and thence restart the tuning process. In this instance, the
TUNE” icon will remain on the display after you press the
[
A
](
TUNE
)
key. If this happens, do not press the
[
A
](
TUNE
)
key repeatedly. The transceiver will remain in the receive
mode as it retracts (this may take up to one minute). There-
after, the transmitter will be engaged, and the ATAS-100/-
120 will be automatically adjusted for best SWR. The
TUNE” icon will then disappear from the LCD, and you
will be ready for operation.
TRANSMITTER OPERATION
External Wattmeters
If you wish to use an external wattmeter in conjunction with
the transceiver and your ATAS-100/-120, please check the
wattmeter with an Ohmmeter prior to installation. Be sure
there is a direct connection between the “In” and “Out” jacks
of the wattmeter (zero resistance), and also ensure that there
is a completely open circuit between the center pin and shield
of the wattmeters output jack. Some wattmeters use a coil
or other device which shorts the center pin to ground at DC,
and this type of internal wattmeter circuitry will not allow
the tuning function of the ATAS-100/-120 to operate.
Operation on 30/17/12 Meters
Although the ATAS-100/-120 is not specified for opera-
tion on the above bands, and optimum operation is there-
fore not guaranteed, the ATAS-100/-120 generally can be
tuned successfully on these bands (some manual adjustment
may be required). Operation of the ATAS-100/-120 on these
bands will not damage the antenna’s components; please feel
free to experiment on these bands, if you like.
ACTIVE-TUNING ANTENNA SYSTEM
(
ATAS-100/-120
)
OPERATION
44

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yaesu FT-897D bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yaesu FT-897D in de taal/talen: Engels als bijlage per email.

De handleiding is 3,3 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info