478500
36
Verklein
Vergroot
Pagina terug
1/76
Pagina verder
Page 34 FT-897D OPERATING MANUAL
TRANSMITTER OPERATION
FM TRANSMISSION
Basic Setup/Operation
1. Press the MODE
(
)
or MODE
(
)
key so as to select
the FM mode.
2. Press the microphone’s PTT switch, and speak into the
microphone in a normal voice. Release the PTT switch
to return to the receive mode.
3. If you get reports that your modulation level is too high
or too low, you may need to adjust the FM-mode micro-
phone gain. The procedure is similar to that used on SSB:
Press the
[
F
]
key momentarily, then rotate the MEM/
VFO CH knob, as needed, until Multi Function Row
“i”
[
MTR, PWR, DISP
]
appears on the display, then
press the
[
A
](
MTR
)
key to select the “Deviation”
meter function (“MOD” will appear above the
[
B
]
key).
4. Press and hold in the
[
F
]
key for one second to enter the
Menu mode.
5. Rotate the MEM/VFO CH knob to recall Menu Mode
No-051
[
FM MIC GAIN
]
.
6. Rotate the DIAL to increase or decrease the setting of
the FM Mic Gain, depending on the level correction re-
quired, then press and hold in the
[
F
]
key to save the
new setting.
7. Close the PTT switch, and while speaking into the mi-
crophone observe the meter indication; the proper set-
ting of the FM Mic Gain will produce eight “bars” of
indication on voice peaks, slightly less on lower levels
of speech input.
8. When done, press and hold in the
[
F
]
key to save the
new setting for the FM-mode microphone gain.
9. The VOX feature is operational during FM transmission.
From Multi Function Row “d”
[
RPT, REV, VOX
]
, press
the
[
C
](
VOX
)
key to activate/deactivate VOX.
Repeater Operation
1. Press the
[
F
]
key momentarily, then rotate the MEM/
VFO CH knob, as needed, until Multi Function Row
“d”
[
RPT, REV, VOX
]
appears on the display.
2. Press the
[
A
](
RPT
)
key to activate repeater operation.
One press of the
[
A
](
RPT
)
key will have set the trans-
ceiver for “Minus Shift” operation. In this situation, you
will observe the “” indicator on the display. The trans-
mitter frequency will be shifted down by a default value
so as to access the repeater input frequency. If your re-
peater uses a positive shift (instead of negative), press
the
[
A
](
RPT
)
key again; the “+” indicator will replace
the “” indicator on the display. Set the transceivers
receiver to the repeater output (downlink) frequency.
Close the PTT switch and speak into the microphone.
You will observe that the transmitted frequency has
shifted according to the setting of the
[
A
](
RPT
)
key in
the Multi Function Row “d”
[
RPT, REV, VOX
]
. Release
the PTT switch to return to the Receive mode.
3. If the default repeater shift is not appropriate for the ma-
jority of the repeaters your area, it may be set indepen-
dently for each band. To change the default repeater shift:
Press and hold in the
[
A
](
RPT
)
key for one second.
This instantly recalls Menu Mode No-076
[
RPT
SHIFT
]
.
Rotate the DIAL knob to select the desired shift fre-
quency.
When done, press and hold in the
[
F
]
key for one
second to save the new setting and exit to normal
operation.
European Version
Version A
2-m
145.1 145.5
145.6 145.8
146.0 146.4 147.0 147.6 148.0
146.6 147.4
Euro Version 1
Euro Version 2
Version A
70-cm
440.0 445.0 450.0
439.45438.20
433.00 433.40
ARS-Repeater Subbands
4. If your repeater uses controlled access (using either
CTCSS or DCS), press the
[
F
]
key momentarily, then
rotate the MEM/VFO CH knob one click clockwise to
cause Multi Function Row “e”
[
TON, -----, TDCH
]
to ap-
pear on the display. Now select the appropriate tone ac-
cess system:
Press the
[
A
](
TON
)
key to activate the CTCSS tone
encoder, which provides a subaudible repeater ac-
cess tone. One press of the
[
A
](
TON
)
key will acti-
vate the CTCSS tone encoder. In this situation, you
will observe the “TEN” indicator on the display. If
36

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yaesu FT-897D bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yaesu FT-897D in de taal/talen: Engels als bijlage per email.

De handleiding is 3,3 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info