805648
1
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
EN – 18V LI-ION CORDLESS
AIR COMPRESSOR – CAP110
OPERATION MANUAL
WARNING: PLEASE READ THE MANUAL CAREFULLY
BEFORE USING THE UNIT!
A. Pneumatic hose
B. Ball adapter
C. Tapered adapter
D. ON/OFF trigger
E. Battery
F. Battery release button
G. Pressure gauge
H. Air chuck
I. Hose storage area
J. Self-locking switch
K. Charger
L. LED light
EXPLANATION OF THE SYMBOLS
Denotes risk of personal injury, loss of life or
damage to the tool in case of non-observance of
the instructions in this manual.
This device is suitable for indoor use only.
Protection class II: Device equipped with a
reinforced insulation without metallic part
accessible. Does not require a plug connected to
the earth.
Take defective components to a special refuse
collection point. Ask about these at your
specialist shop or local council.
A
FIG. 1
H F
C
K
B
E
I
D
J
L
G
SAFETY INSTRUCTIONS
WARNING!
Read all safety warnings and all instructions. Failure
to follow the warnings and instructions may result
in electric shock, fire and/or serious injury. Save all
warnings and instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
1. WORK AREA SAFETY
a. Keep work area clean and well lit. Cluttered or dark areas invite
accidents.
b. Do not operate power tools in explosive atmospheres, such as
in the presence of flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
c. Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control.
2. ELECTRICAL SAFETY
a. Power tool plugs must match the outlet. Never modify the plug in
any way. Do not use any adapter plugs with earthed (grounded)
power tools. Unmodified plugs and matching outlets will reduce
risk of electric shock.
b. Avoid body contact with earthed or grounded surfaces, such as
pipes, radiators, ranges and refrigerators. There is an increased
risk of electric shock if your body is earthed or grounded.
c. Do not expose power tools to rain or wet conditions. Water
entering a power tool will increase the risk of electric shock.
d. Do not abuse the cord. Never use the cord for carrying, pulling or
unplugging the power tool. Keep cord away from heat, oil, sharp
edges or moving parts. Damaged or entangled cords increase the
risk of electric shock.
e. When operating a power tool outdoors, use an extension cord
suitable for outdoor use. Use of a cord suitable for outdoor use
reduces the risk of electric shock.
f. If operating a power tool in a damp location is unavoidable, use
a residual current device (RCD) protected supply. Use of an RCD
reduces the risk of electric shock.
3. PERSONAL SAFETY
a. Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use a power tool while you are
tired or under the influence of drugs, alcohol or medication.
A moment of inattention while operating power tools may result in
serious personal injury.
b. Use personal protective equipment. Always wear eye protection.
Protective equipment such as dust mask, non-skid safety shoes,
hard hat, or hearing protection used for appropriate conditions
will reduce personal injuries.
c. Prevent unintentional starting. Ensure the switch is in the off-
position before connecting to power source and/or battery pack,
picking up or carrying the tool. Carrying power tools with your
finger on the switch or energising power tools that have the switch
on invites accidents.
d. Remove any adjusting key or wrench before turning the power
tool on. A wrench or a key left attached to a rotating part of the
power tool may result in personal injury.
e. Do not overreach. Keep proper footing and balance at all times.
This enables better control of the power tool in unexpected
situations.
f. Dress properly. Do not wear loose clothing or jewellery. Keep your
hair, clothing and gloves away from moving parts. Loose clothes,
jewellery or long hair can be caught in moving parts.
g. If devices are provided for the connection of dust extraction and
collection facilities, ensure these are connected and properly
used. Use of dust collection can reduce dust related hazards.
4. POWER TOOL USE AND CARE
a. Do not force the power tool. Use the correct power tool for your
application. The correct power tool will do the job better and
safer at the rate for which it was designed.
b. Do not use the power tool if the switch does not turn it on and
off. Any power tool that cannot be controlled with the switch is
dangerous and must be repaired.
c. Disconnect the plug from the power source and/or the battery
pack from the power tool before making any adjustments,
changing accessories, or storing power tools. Such preventive
safety measures reduce the risk of starting the power tool
accidentally.
d. Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of
moving parts, breakage of parts and any other condition that
may affect the power tool’s operation. If damaged, have the
power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting
tools with sharp cutting edges are less likely to bind and are
easier to control.
g. Use the power tool, accessories and tool bits etc. in accordance
with these instructions, taking into account the working
conditions and the work to be performed. Use of the power tool
for operations different from those intended could result in a
hazardous situation.
5. BATTERY TOOL USE AND CARE
a. Recharge only with the charger specified by the manufacturer.
A charger that is suitable for one type of battery pack may
create a risk of fire when used with another battery pack.
b. Use power tools only with specifically designated battery packs.
Use of any other battery packs may create a risk of injury and
fire.
c. When battery pack is not in use, keep it away from other metal
objects, like paper clips, coins, keys, nails, screws or other small
metal objects that can make a connection from one terminal
to another. Shorting the battery terminals together may cause
burns or a fire.
d. Under abusive conditions, liquid may be ejected from the
battery; avoid contact. If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
6. SERVICE
a. Have your power tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the safety
of the power tool is maintained.
7. SAFETY WARNINGS FOR BATTERY
a. Never attempt to open or modify battery for any reason.
Released electrolyte is corrosive and may cause damage to eyes
and skin. It may be toxic if swallowed.
b. Under extreme conditions, battery leakage may occur. When
you notice liquid on the battery, proceed as follows:
Carefully wipe the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions below.
The battery fluid, a 25 - 30% solution of potassium hydroxide,
can be harmful. In case of skin contact, immediately rinse with
water. Neutralize with a mild acid such as lemon juice or vinegar.
In case of eye contact, rinse abundantly with clean water for at
least
10 minutes.
c. Do not expose to water.
d. Do not store in locations where the temperature may
exceed 40 °C.
e. Charge at room temperature: 0 °C - 45 °C.
It is normal for the battery charger to hum and be warm
but not hot during operation.
f. Charge only using the charger provided with the tool.
g. Before charging, make sure that the battery is dry and clean.
h. Use only the battery supplied with your tool.
i. Exercise care in handling and storing batteries in order not to
short them with conductive materials such as rings, keys, coins.
There is a real risk of the battery or the conductor overheating,
causing fire or burns.
j. Do not dispose of battery in fire. It may explode. Follow
instructions and regulations given by local authorities
concerning environmental protection. Dispose of old
batteries at an appropriate waste disposal facility.
8. SAFETY WARNINGS FOR CHARGERS
a. Before using the charger and the battery pack, read the
instruction manual carefully.
b. During charging, the electrical current used must correspond to
the specifications of the battery charger.
c. Never allow moisture, rain or splash to reach the recharging
location.
d. The ambient temperature should never exceed 40 °C.
Never expose the unit to direct sunlight.
e. A faulty or damaged battery pack or no longer accepting a load
must be disposed of at a special collection point. Respect the
environment. Do not dispose of an unusable battery pack with
household waste in the fire or in water.
f. Use only the battery pack supplied by the manufacturer.
g. Always keep the surface of the charger free of dust and dirt.
h. Insert the battery pack into the charger. Follow the polarity
guides.
i. Always remove the battery pack before performing any
operation on the device.
j. When the battery is disconnected from the tool, cover the
contacts to avoid a short circuit (e.g. from tools).
k. Do not throw the battery in water or fire, risk of explosion!
l. Protect the battery case from shocks and do not open it.
m. Never discharge the battery completely and recharge it
regularly if you do not use it for an extended period of time.
n. Indoor use only. Do not recharge the battery in rain or in wet
conditions.
WARNING!
This device produces an electromagnetic field
during operation. This field may interfere in certain
circumstances with active or passive medical
implants. To reduce the risk of serious or fatal injury,
we recommend that people with medical implants
consult with their physician and the medical implant
manufacturer before using this device.
9. INTENDED USE
The appliance is intended for inflating car and bicycle tyres, and
inflatable items for games, sport and leisure, but not for pumping
up inflatable items with a large volume, such as inflatable
boats and very large air beds. The appliance is not intended for
professional use.
10. ADDITIONAL SAFETY INSTRUCTIONS
1. Know your air compressor. Read operator’s manual carefully.
2. Learn its applications and limitations, as well as the specific
potential hazards related to this tool. Following this rule will
reduce the risk of electric shock, fire, or serious injury.
3. Risk of bursting. Do not operate air compressor to result in
output pressure greater than marked maximum pressure of item
to be inflated. Do not use at pressure greater than 7.5 bar.
4. To reduce the risk of electric shock, do not expose to rain. Store
indoors.
EN - manual Luchtpomp 18V CPS01180000MO.indd 1 10/01/2018 14:12
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Wolfgang Tools CAP110 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Wolfgang Tools CAP110 in de taal/talen: Engels als bijlage per email.

De handleiding is 0.63 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Wolfgang Tools CAP110

Wolfgang Tools CAP110 Gebruiksaanwijzing - Nederlands - 2 pagina's

Wolfgang Tools CAP110 Gebruiksaanwijzing - Deutsch - 2 pagina's

Wolfgang Tools CAP110 Gebruiksaanwijzing - Français - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info