587883
7
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
7
Before Starting
Prior to initial operation, check the unit for any visual de-
fects on the control and safety devices, that the unit has
been installed correctly and that it has been properly
connected to the mains.
Observe the following points:
à Install the unit in a stable position.
à Make sure that air is supplied for combustion.
à Make sure that the air can be sucked in and be ex-
hausted freely.
à Avoid overpressure and underpressure in the room
where the unit has been installed.
à Make sure that enough fuel is supplied.
à Please note: the multifilex oil preheater will only func-
tion properly if voltage is supplied to the unit for a
longer time prior to initial operation.
à Use only clean heating oil or diesel.
Do not use bio diesel.
Additional information
The waste gas values of the oil-burner are to be
checked and properly adjusted by authorised personnel
to ensure compliance with local requirements.
Paraffin accumulation at low outside temperatures
A sufficient amount of heating oil must be able to flow
freely even when temperatures are low.
à Paraffin can accumulate even at temperatures below
5 °C.
à Appropriate measures must be taken to prevent this.
Use winterised heating oil or winter diesel.
Connection to the power supply
The units are operated with 400 V / 3~N / 50 Hz.
à The unit is connected to the power supply by an at-
tached power cable with a grounded contact plug.
à Extension cables may only be laid by authorised
electricians based on the capacity of a unit, the
length of the cable and in accordance with the in-
tended use.
G
The unit must be connected to the power supply at
a special terminal equipped with a switch to pro-
tect against faulty currents.
G
Extension cables may only be used once they are
unrolled.
G
Flexible fuel tubes must be protected from being
damaged, e.g. from forklifts, animals, etc.
Starting
Only those persons who have been trained in operation
of the unit may be responsible for operating and moni-
toring it.
Important information about starting the cold unit
The preheating of the nozzle stock delays the tempera-
ture depending start of the CLK 30 to CLK 70 units de-
livered with forced-air burners.
Connecting the unit to the power supply
1. Set the operating switch to “0” (OFF).
2. Connect the unit plug to a properly connected power
socket.
3. Open all shut-off fittings in the oil supply.
When operating the unit for the first time, air in the oil
supply can cause the burner to malfunction.
1. Plug the supplied bridge circuit plug
2 into the thermostat socket 1 of the
control panel.
2. Set the operating switch to I
heating.
Heating without a room thermostat
The unit runs in continuous operation.
1 2
Control Panel
bridge circuit plug
thermostat socket
reset button (burner)
control lamp, red (burner malfunction)
operating switch
control lamp, green (in operation)
safety temperature limiter
Note about the green control lamp (in operation).
The control lamp indicates that the unit is in
“heating”
mode.
When the unit is in
“ventilation” mode, nothing is dis-
played if the room thermostat is switched off or if the
STB was activated.
Ventilation
In this position only the supply air fan runs and the unit
can be used for air circulation.
1. Set operating switch to “II (ventilation).
2. Please note: in this mode, it is not possible to use
the thermostat nor can the unit be operated in
heating mode.
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw REMKO CLK50 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van REMKO CLK50 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,02 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van REMKO CLK50

REMKO CLK50 Gebruiksaanwijzing - Nederlands - 16 pagina's

REMKO CLK50 Gebruiksaanwijzing - Deutsch - 20 pagina's

REMKO CLK50 Gebruiksaanwijzing - Français - 16 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info