587883
5
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
5
Monitoring operation of device
All functions of the unit are fully automatic and moni-
tored for safety by the safety facility and the automatic
burner relay (part of the forced-air burner).
If the flame burns irregularly or goes out, the unit is
switched off by the automatic burner relay. The control
lamp on the control panel and the malfunction lamp of
the automatic burner relay light up.
Before the unit can be restarted, the automatic burner relay
must be released by pressing the external reset button on
the operating panel or the reset button on the automatic
burner relay.
The fan control (TR) regulates operation of the fan. The
temperature monitor (TW) limits or regulates the tem-
perature of the unit in heating mode.
The safety temperature limiter (STB) interrupts heating
mode when extreme overheating occurs or if the tem-
perature monitor (TW) stops working or is defective.
The STB can only be manually released after the unit
has cooled down.
G
Before the STB is released to begin operation
again, the reason the STB was activated must be
determined.
Installation Requirements
The heaters may only be installed in compliance with
the relevant regulations, in particular, regulations gov-
erning the installation and operation of fireplaces and
furnaces.
Any national/regional emission control laws or regula-
tions must also be observed.
à Avoid under- or overpressure in the room where the
unit is installed, as this would result in combustion
troubles.
à Make absolutely sure that the opening for air intake
and output is adjusted to the fan power (see model
plate).
If this is not possible, the burner has to be equipped
with a separate air supply device to ensure optimum
combustion.
Installation in closed, well aerated rooms without
connection to a chimney
à The units may only be operated when the minimum
amount of air required for combustion is supplied.
à A safe exhaustion of the waste gases is to be en-
sured to exclude inadmissible pollution.
- Fresh air is supplied from below.
- Waste gases are expelled upwards.
Outside installation
à Operation of the unit may not have any harmful ef-
fects or cause any unreasonable problems.
à The unit operator must ensure that unauthorised per-
sons are prevented from manipulating the unit or its
power supply.
à Because rain and snow can be sucked in by the air
supply fan, a suitable protective covering should be
used.
Heating Rooms
à Warm air generators may only be operated with a
room thermostat when heating rooms.
Accessories.
à Make sure that there is enough fresh air to ensure
optimum combustion.
Safety zones
à To ensure safe operation and guarantee unhindered
access to the unit for maintenance work, a safety
zone of 1.5 m should be maintained around the unit.
à Floors and ceilings must be fire-resistant.
Electrical Connection
à The units are operated with 400 V / 3~N / 50 Hz.
à The unit must be connected to the power source at a
special terminal equipped with a switch to protect
against faulty currents.
à Extension cable may only be laid by authorised elec-
tricians based on the capacity of a unit, the length of
the cable and in accordance with local requirements.
à All extension cable may only be used once they have
been unrolled.
G
While the unit is in operation, the safety features
may not be bypassed or blocked!
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw REMKO CLK50 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van REMKO CLK50 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,02 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van REMKO CLK50

REMKO CLK50 Gebruiksaanwijzing - Nederlands - 16 pagina's

REMKO CLK50 Gebruiksaanwijzing - Deutsch - 20 pagina's

REMKO CLK50 Gebruiksaanwijzing - Français - 16 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info