562258
5
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
IDENTIFICATION OF CONTROLS
1 o (STANDBY)
With the corresponding end of the mains power cord connected
to the AC mains input of the D7050 and the plug connected to a
mains power source, press o (Standby) to switch ON the D7050
from standby mode. The Standby indicator will turn from amber to
bright/white color. Pressing o (Standby) again turns the unit back
to standby mode.
IMPORTANT NOTES ABOUT STANDBY MODE
The following conditions describe Standby Mode response with respect
to AUTO SHUTOFF as congured in the D 7050 app. Refer to section below
about "NAD D 7050 APP" for further information.
Condition 1
AUTO SHUTOFF in the D 7050 app is set to “ON”
D 7050 will automatically go to standby mode if there are no user
interface interaction and no active source within 30 minutes.
Condition 2
AUTO SHUTOFF in the D 7050 app is set to “OFF” or no D 7050 app is used
to control the D 7050
D 7050 will not go to standby mode at any time unless directly initiated
by pressing o (Standby) switch or OFF from the remote control.
The default setting of AUTO SHUTOFF is OFF.
2 VOLUME
Adjust audio level by turning clockwise or counterclockwise.
3 INPUT
Rotate to select desired input source.
4 DISPLAY
Illuminate the selected or active source (COAXIAL1, COAXIAL2,
OPTICAL1, OPTICAL2, COMPUTER, AIRPLAY, DOCK, BT) and current
audio level.
Display follows the orientation of the unit - vertical or horizontal
view as shown on the front cover.
IMPORTANT NOTE
Display shall temporarily turn o if there is no user interface interaction
within 5 minutes. Restore display by sending a remote control
command or rotating any of the controls.
5 PHONES
A 3.5 mm stereo jack socket is supplied for headphone listening.
Specially designed low noise headphone circuitry can accommodate a
wide range of phones, even 600 Ohm studio models.
Adjust headphone audio level by rotating the VOLUME control
clockwise or counterclockwise.
Ensure that the volume control is turned to minimum (fully
counterclockwise) before connecting or disconnecting
headphones. Listening at high levels can damage your hearing.
Inserting a headphone jack into this socket automatically switches
o the loudspeakers.
6 RESET
Restore factory default settings.
7 WPS/JB
Use to setup wireless network connection.
8 AUDIO OUT
These output terminals have dual function. They are used either as
PRE OUT or SUBWOOFER terminals.
Always turn OFF the D 7050 and associated external devices before
connecting or disconnecting anything to the AUDIO OUT sockets.
PRE OUT
The AUDIO OUT sockets can be used to drive an additional amplier.
Use a dual RCA cable to connect AUDIO OUT to the corresponding
analog audio input of compatible devices such as ampliers,
receivers or other applicable devices.
AUDIO OUT will be aected by the D 7050’s volume control settings.
Rotate the VOLUME control to adjust the output level of the AUDIO
OUT sockets.
SUBWOOFER
Use a dual RCA cable to connect AUDIO OUT to the low level input
of a powered subwoofer.
Low frequency information up to 200Hz is sent to the connected
subwoofer via AUDIO OUT.
AUDIO OUT
+12V
TRIGGER
IN
OPTICAL
COMPUTER
DIGITAL AUDIO INPUT
LAN
100-240V 50/60Hz
SPEAKERS
RI G HT
LE F T
WPS/JBRESET
21
1
2
L
R
COAXIAL
6 7 8 9
10 11 12 13 14 15
2
1
3
4
5
5
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
5

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

NAD-D7050

Zoeken resetten

  • Mijn NAD van 2016 schakelt de laatste tijd na een minuut automatisch uit. Ik hoor het relais klikken en moet dan opnieuw opstarten. Iemand die me een suggestie voor een oplossing kan bieden?
    Gesteld op 1-1-2019 om 11:38

    Reageer op deze vraag Misbruik melden
    • Ik heb hetzelfde probleem. Schakelt na 0 tot 10 minuten steeds weer uit. Reset e.d. helpen niet. Wn dat van een zogenaamd kwaliteitsproduct? Geantwoord op 5-10-2019 om 19:06

      Waardeer dit antwoord (9) Misbruik melden
    • Hebben jullie hier al een antwoord op?
      Ik handig probleem ook dat de NAD C268 na ongeveer 10 minuten vanzelf op stand-by springt terwijl de muziek nog draait. Geantwoord op 23-1-2022 om 11:52

      Waardeer dit antwoord (2) Misbruik melden
    • Zojuist bij de NAD versterker van oma, 1 van de speakerkabels los gehaald. Volgens de audio expert gaf aan dat het uitschakelen een beveiliging is. Wanneer er kortsluiting ontstaat bijv.
      Het kan ook in de speakers zelf zitten. Een korte test bleek dat bij oma 1 van haar kabels kapot was. Overigens niet aan de buitenkant te zien. Geantwoord op 9-4-2022 om 18:03

      Waardeer dit antwoord Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw NAD D7050 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van NAD D7050 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,03 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van NAD D7050

NAD D7050 Gebruiksaanwijzing - Nederlands - 20 pagina's

NAD D7050 Gebruiksaanwijzing - Deutsch - 16 pagina's

NAD D7050 Installatiehandleiding - English - 2 pagina's

NAD D7050 Gebruiksaanwijzing - Français - 16 pagina's

NAD D7050 Gebruiksaanwijzing - Espanõl - 20 pagina's

NAD D7050 Gebruiksaanwijzing - Svenska - 16 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info