509113
5
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
- 5 -
You can check that it has been set correctly by looking at the device configuration window, which is
accessed by pressing the ‘Configure Device’ button. (Note: photoGPS time is UTC, not local time.)
The photoGPS contains a rechargeable battery, which is charged simply by connecting the device to
a USB port. When connected, a constant red status LED indicates ‘charging’ and a constant green
status LED indicates ‘fully charged’. The charging status is also indicated in the photoGPS
configuration window. Ideally, you should fully charge the photoGPS before using it. This should
take no longer than a couple of hours.
Once you have checked that your device has been charged, and its clock is set, you are ready to test
the device. Please follow these steps to confirm that everything is working before going out and
using your device:
1. Place the photoGPS onto the camera's hot shoe
2. Take a picture, whilst observing the photoGPS LEDs.
When the shutter is pressed the LED light should flash green once. If this is the case, you are now
ready to go outside and start taking geotagged photographs. If not, consult the Troubleshooting
section.
6. Capturing Locations with photoGPS
Your photoGPS is extremely easy to use. Simply connect it to your camera via the hot shoe and take
photos as normal. Each time you take a photo, the green status LED should flash once as the device
captures GPS data for the current location. If this is not the case, consult the Troubleshooting
section at the end of this guide.
The photoGPS works by receiving GPS signals transmitted by satellites and therefore needs a good
view of the sky to function well. So, if possible, try to avoid taking photos next to walls, when
surrounded by tall buildings or indoors etc.
Of course, this is not always possible and sometimes you will want to take geotagged photos in
areas where there is poor GPS reception e.g. indoors. The JOBO photoGPS solution allows you to do
this. Simply press the device GeoHint button before you enter such an area and it will capture the
location. This can be used later, by the photoGPS software, as a hint to help geotag photos taken
inside the area of poor GPS reception.
If you forget to press the GeoHint button before entering the area, no problem, pressing the button
after leaving the area will work just as well. If you forget to press the GeoHint button at all, the
photoGPS software will still try to geotag your photos based on the positions of any earlier/later
photos and/or GeoHints.
An alternative to the GeoHint button is simply to take a photograph (with the photoGPS on the
camera) either before entering or after leaving the area of poor GPS reception. The disadvantage of
this approach is that you may have to take a photo that you don’t really want in order to geotag
those that you do.
For the best results it is advisable to keep the photoGPS connected to the camera for all photos you
wish to geotag. However, if this is not possible (e.g. the hot shoe is required for an external flash)
then the device can be removed temporarily. The photoGPS software will still try to geotag your
photos based on based on the positions of any earlier/later photos and/or GeoHints.
Tip: If you wish to take geotagged photos in an area of poor GPS reception, it may be better to use
the GeoHint button, as described, and remove the photoGPS from the camera when taking photos in
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Jobo photoGPS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Jobo photoGPS in de taal/talen: Engels als bijlage per email.

De handleiding is 1,27 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Jobo photoGPS

Jobo photoGPS Gebruiksaanwijzing - Deutsch - 23 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info