534549
3
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
2
2 3
ENGLISH
Speaker Placement
Expanding a 5.1-Channel System to a 7.1-Channel System
The surround back speakers should be placed against the rear wall directly behind the
listeners, 3–6 feet (0.9m–1.8m) apart, 5–6 feet (1.5m–1.8m) off the floor.
Surround Back
Right Speaker
3 - 6 ft
(0.9m - 1.8m)
5 - 6 ft
(1.5m - 1.8m)
Surround Back
Left Speaker
Center
Speaker
If original surround speakers are
behind listeners, move them to a point
to directly at listeners' sides
Front Left
Speaker
Surround Left
Speaker
Surround Right
Speaker
Surround Back
Right Speaker
Surround Back
Left Speaker
Front Right
Speaker
Subwoofer
TV
NOTE: If your original surround speakers are located behind the listeners, you should move
them up so they are directly to the listeners sides.
If You’re Adding to an Existing HKTS 30 Speaker System:
Your HKTS30SAT-2 speakers are designed to expand an existing HKTS30 speaker system
from 5.1 channels to 7.1 channels. You can connect the HKTS30SAT-2 speakers to your
receiver’s or amplifier’s surround back left and surround back right outputs.
If You’re Adding to an Existing HKTS 20 Speaker System:
Your HKTS30SAT-2 speakers are designed to expand an existing HKTS20 speaker system
from 5.1 channels to 7.1 channels by replacing the existing front left and front right
speakers. You can then connect your existing HKTS20 front left and front right speakers to
your receiver’s or amplifiers surround back left and surround back right outputs.
Mounting Options for HKTS30SAT-2 Speakers
Shelf Placement
You can place the HKTS30SAT-2 speakers on
shelves. The satellite speakers have built-in bases
for shelf placement. You can also remove the
bases if desired.
To remove a speaker’s base, pull it straight off the
speaker, as shown in the illustration. Applying
even pressure to both sides of the base will allow
it to slide off smoothly.
Wall-Mounting
IMPORTANT: Read the Speaker Connections
section, on page 5, before wall-mounting the
HKTS30SAT-2 speakers. You will need to insert
the speaker wires through the wall mounts and
connect the wires to the speakers during the
process of installing the wall-mounts.
NOTE: If you are using your own speaker wire, it must be no
thicker than the wire supplied with the speakers. Thicker wire will
prevent the wall-mount bracket from sliding onto the speaker.
Decide on the location for the speaker 1.
(see Speaker Placement, opposite).
Remove the speaker’s base as explained in 2. Shelf Placement, above.
Disassemble the wall-mount bracket by sliding the two sections apart, as shown in 3.
the illustration.
Attach the wall portion of the wall-mount onto the wall using hardware that is 4.
appropriate for the wall’s construction and materials. We recommend first anchoring
the mount using its keyhole, then attaching it with another anchor through its top
opening, as shown in the illustration. Note that the HKTS30SAT-2 speakers weigh
3.3 lb (1.5kg). Be sure to use hardware that can support this weight.
Top Opening
Keyhole Opening
Bottom Opening
Apply Pressure Evenly
to Both Sides of Base
Lift Base Straight
off Speaker
Pull Sections
Apart
0209CSK - HK HKTS30SAT-2 Inlay.indb 3 09/04/10 8:56:01
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Harman Kardon HKTS30SAT-2 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Harman Kardon HKTS30SAT-2 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,92 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Harman Kardon HKTS30SAT-2

Harman Kardon HKTS30SAT-2 Gebruiksaanwijzing - Nederlands - 8 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info