463800
3
Verklein
Vergroot
Pagina terug
1/6
Pagina verder
echoInstallationInstructions 3

Notice
Do not cut the transducer cable. Cutting the transducer cable will void your
warranty.
1. Feed the 20 in. (50 cm) cable tie
through the slot on the transducer
mount
, with the ridges of the cable tie facing up, until equal lengths
extend on both sides of the mount.
For use in cold water or in areas with heavy timber or debris, use a metal
4–5 in. worm gear clamp (not included) instead of the cable tie.
2. Position the mount gasket
on the curved top of the transducer mount.
3. Place the transducer mount against the body of the trolling motor with the
front of the transducer pointed away from the propeller.
4. Secure the 20 in. (50 cm) cable tie around the body of the trolling motor,
but do not fully tighten the cable tie.
5. Properly align the gasket between the transducer mount and the body of
the trolling motor, and tighten the cable tie.
If necessary, trim the excess cable tie.
6. Position the transducer so that it will be parallel with the bottom when
in use, tighten the 10-32 locking nut
until it touches the mounting
bracket, and tighten
1
/
4
turn more (do not overtighten).
7. Use the supplied 5
1
/
2
in. (14 cm) cable ties
to secure the transducer
cable to the motor shaft.
If necessary, ll the forward-facing portion (except the cable tie pocket)
of the transducer mount with sealant to avoid accumulation of debris.
8. Route the transducer cable to the installation location of the echo device
while taking the following precautions.
Avoid routing the cable close to electrical wires or other sources of
electrical interference.
Make sure that the cable will not become pinched when the trolling
motor is deployed and recovered.

1. Select a mounting location (page 3).
2. Prepare the swivel-mount base (page 3).
3. Fasten the mount with the cables installed in the mount (page 4), or
without the cables installed in the mount (page 4).

Select a location to install the swivel mount, while considering these
guidelines.
The location provides a clear view of the screen and access to the keys on
the echo.
The location is sturdy enough to support the device and the mount.
You can route the cables either from under the swivel mount, or from
behind the device.
The location is the appropriate distance from a compass (page 6).

Notice
Use pan-head screws or bolts when securing the swivel-mount base. Screws
or bolts with countersunk heads will damage the base.
1. After you have chosen the location to install the swivel mount (page 3),
determine whether you will attach the mount to the surface using screws
or bolts, and choose the appropriate fastening hardware:
To attach the base with screws, use self-tapping, pan-head wood
screws, either size #8 or a diameter of
5
/
32
in. (4 mm), with an
appropriate drill bit for the pilot hole.
To attach the base with bolts, use pan-head bolts, either size #8 or a
diameter of
5
/
32
in. (4 mm), with the appropriate washers and nuts. Use
a drill bit of the same diameter as the bolt.
2. Separate the swivel base from the mount.
3. If you plan to route the cables from
under the mounting surface, orient the
swivel base so that the pass-through
holes
face the desired direction.
4. Using the swivel base as a template,
mark the pilot hole locations
.
5. If you plan to route the cables from
under the mounting surface, mark the
location in the center
.
6. Using the appropriate drill bit for the
hardware, drill the three pilot holes.
7. If you plan to run the power and transducer cables from under the
mounting surface, use a
5
/
8
in. (16 mm) drill bit to drill a hole through the
mounting surface at the location you marked in step 5.
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Garmin Echo 100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Garmin Echo 100 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,71 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Garmin Echo 100

Garmin Echo 100 Installatiehandleiding - Nederlands - 6 pagina's

Garmin Echo 100 Gebruiksaanwijzing - Nederlands - 12 pagina's

Garmin Echo 100 Installatiehandleiding - Deutsch - 6 pagina's

Garmin Echo 100 Gebruiksaanwijzing - Deutsch - 12 pagina's

Garmin Echo 100 Gebruiksaanwijzing - English - 12 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info