520200
6
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
6
6 LED indications
LED Color
GSM OK
green
Is lit if the unit is connected to the network and field strength
is appropriate.
Appropriate field strength: 2 (on the scale of 0-5)
GSM / SIM ERROR
red
Is lit continuously if the unit is not connected to the network.
The following cases are possible:
- the GSM antenna is not connected or is faulty
- the SIM card is not inserted, or PIN code request is not
deactivated, or the card is faulty.
CALL IN PROGRESS
green Call or conversation is in progress.
VOLTAGE OUT
red Voltage output activated (e.g. electric lock control)
RELAY CONTROL
red Relay output activated (e.g. gate control)
7 Installation
7.1 Mounting
Measure the GSM signal with your mobile phone. It may happen that in the desired place of
installation the signal strength is not satisfactory. In this case you can move the unit or the
GSM antenna in a more suitable place before installation.
Do not mount the unit where it could be affected by strong electromagnetic disturbances.
Do not mount the unit in wet places or in places with a high degree of humidity.
Connecting the antenna: the GSM antenna can be connected to the SMA connector. The
antenna supplied with the unit provides good transmission under normal reception
circumstances. In case of having signal strength problems or/and wave interference (fading),
use other type of antenna or find a more suitable place for the unit.
Inserting the SIM card: turn the SIM card with the metallic contact surface downwards
towards the panel, and the cut corner should point towards the panel’s center. Insert the
card in this position in the socket and press until it clicks. To remove the SIM card, push it
towards the socket then pull it out.
7.2 Putting into operation
Disable PIN code request, voicemail and missed call notification service on the SIM card.
Enable caller identification and caller ID sending service on the SIM card at the GSM service
provider.
Make sure the SIM card is inserted properly into its socket.
Make sure the antenna is fixed properly into the SMA connector.
Make sure the wiring is done as shown in the wiring diagram.
Power up the unit (12-24V AC/ DC). Make sure the power supply is sufficient for the
operation of the unit. If operating from a 16V AC transformer, the necessary current is min.
300mA (5VA).
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Estom AS1-GSM bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Estom AS1-GSM in de taal/talen: Engels als bijlage per email.

De handleiding is 1,43 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info