624852

Casio 5365 - PRW-6000 Handleiding

13
Verklein
Vergroot
Pagina terug
1/15
Pagina verder
E-96
Swapping the Home City and World Time City
You can use the procedure below to swap your Home City with your World Time City. This function comes
in handy for those who often travel between two different time zones. The following example shows what
happens when the Home City and World Time City are swapped while the Home City originally is
TOKYO
(
TYO
) and the World Time City is
NEW YORK
(
NYC
).
Home City World Time City
Before swapping
Tokyo
10:08 p.m
(Standard time)
New York
9:08 a.m.
(Daylight saving time)
After swapping
New York
9:08 a.m.
(Daylight saving time)
Tokyo
10:08 p.m.
(Standard time)
• You need to confi gure starting Home City and World Time City settings before performing the
procedure below.
Home City and summer time settings (page E-34)
World Time City and summer time settings (page E-95)
• The procedure below assumes that World Time Mode settings start with the analog hands indicating
New York (NYC) time and the digital display indicating Tokyo (TYO) time.
E-97
To swap your Home City and World Time City
In the World Time Mode, hold down
D
for at least three seconds.
• After
CITY
fl ashes on the digital display, the watch will swap the
Home City and World Time City settings. With the above example, the
second hand will move to
TYO
(Tokyo). The hour and minute hands
will move to the current time in Tokyo (
TYO
).
• The second hand will return to regular timekeeping after about three
seconds.
• With the above example, the digital display will now show the current
time in New York (
NYC
).
To access the UTC (Universal Time Coordinated) time zone
In the World Time Mode, hold down
A
for at least three seconds.
• This will cause
UTC
to fl ash on the digital display, and then the hour
and minute hands will move to the current time in the UTC time zone.
The second hand will move to the UTC city code at this time. The
second hand will return to regular timekeeping after about three
seconds.
E-98
Illumination
The display of the watch is illuminated for easy reading in the dark.
The watch’s auto light switch turns on illumination automatically when
you angle the watch towards your face.
• The auto light switch must be turned on (page E-100) for it to operate.
To turn on illumination manually
Press
L
in any mode to illuminate the display.
• You can use the procedure below to select either 1.5 seconds or three
seconds as the illumination duration. When you press
L
, the display
will remain illuminated for about 1.5 seconds or three seconds,
depending on the current illumination duration setting.
• The above operation turns on illumination regardless of the current auto light switch setting.
• Illumination will turn off automatically if an alarm starts to sound or if you perform a crown operation.
• Illumination will not turn on if a calibration signal receive operation or hand movement operation is in
progress. Also, illumination may not turn on while a sensor is taking a reading.
To change the illumination duration
1. In the Timekeeping Mode, pull out the crown.
2. Press
B
four times. This will cause
LIGHT
to appear on the digital display, along with a fl ashing value
(
1
or
3
) indicating the current illumination duration setting.
3. Rotate the crown to select either
1
(1.5 seconds) or
3
(three seconds) for the illumination duration.
4. After the setting is the way you want, push the crown back in.
C
E-99
About the Auto Light Switch
Turning on the auto light switch causes illumination to turn on,
whenever you position your wrist as described below in any mode.
Moving the watch to a position that is parallel to the ground and
then tilting it towards you more than 40 degrees causes
illumination to turn on.
Warning!
•
Always make sure you are in a safe place whenever you are reading the display of the watch
using the auto light switch. Be especially careful when running or engaged in any other activity
that can result in accident or injury. Also take care that sudden illumination by the auto light
switch does not startle or distract others around you.
•
When you are wearing the watch, make sure that its auto light switch is turned off before riding
on a bicycle or operating a motorcycle or any other motor vehicle. Sudden and unintended
operation of the auto light switch can create a distraction, which can result in a traffi c accident
and serious personal injury.
More than
40°
Wear the watch on the
outside of your wrist
More than
40°
Wear the watch on the
outside of your wrist
E-100
Note
• This watch features a “Full Auto Light”, so the auto light switch operates only when available light is
below a certain level. It does not illuminate the display under bright light.
• The auto light switch is always disabled, regardless of its on/off setting, when any one of the following
conditions exists.
While any tone (alarm, timer, etc.) is sounding
While the watch is in the Digital Compass Mode
While a receive operation is in progress
While a hand movement operation is in progress
• If you have Auto Light enabled, display illumination may be delayed if you angle the watch towards
your face while a barometric pressure, altitude, or temperature reading operation is being performed.
To enable or disable the auto light switch
1. In the Timekeeping Mode, pull out the crown.
2. Press
B
three times. This will cause
AUTO
to appear on the left of the
digital display, along with the fl ashing current auto light switch setting
(
ON
or
OFF
) on the right.
3. Rotate the crown to select either enabled (
ON
) or disabled (
OFF
) for
the auto light switch setting.
4. Push the crown back in.
• The auto light switch turns off automatically whenever battery power
drops to Level 4 (page E-14).
Auto light switch on
indicator
Auto light switch on
indicator
C
E-101
Illumination Precautions
• The LED that provides illumination loses power after very long use.
• Illumination may be hard to see when viewed under direct sunlight.
• Illumination turns off automatically whenever an alarm sounds.
• Frequent use of illumination runs down the battery.
Auto light switch precautions
• Wearing the watch on the inside of your wrist, movement of your arm, or vibration of your arm can
cause frequent activation of the auto light switch and illumination of the display. To avoid running down
the battery, turn off the auto light switch whenever engaging in activities that might cause frequent
illumination of the display.
• Note that wearing the watch under your sleeve while the auto light switch is turned on can cause
frequent illumination of the display and can run down the battery.
• Illumination may not turn on if the face of the watch is more than 15 degrees above
or below parallel. Make sure that the back of your hand is parallel to the ground.
• Illumination turns off after the preset illumination duration (page E-98), even if you
keep the watch pointed towards your face.
• Static electricity or magnetic force can interfere with proper operation of the auto
light switch. If illumination does not turn on, try moving the watch back to the
starting position (parallel with the ground) and then tilt it back towards your face
again. If this does not work, drop your arm all the way down so it hangs at your
side, and then bring it back up again.
• You may notice a very faint clicking sound coming from the watch when it is shaken
back and forth. This sound is caused by mechanical operation of the auto light
switch, and does not indicate a problem with the watch.
E-102
Other Settings
The button operation tone sounds any time you press one of the watch’s buttons. You can turn the button
operation tone on or off as desired.
• Even if you turn off the button operation tone, the alarm, Hourly Time Signal, barometric pressure
change indicator, and Countdown Timer Mode alarm all operate normally.
To turn the button operation tone on or off
1. In the Timekeeping Mode, pull out the crown.
2. Press
B
twice. This will cause the current button operation tone
setting (
KEY
or
MUTE
) to fl ash on the digital display.
3. Rotate the crown to select either on (
KEY
) or off (
MUTE
) for the
button operation tone setting.
4. Push the crown back in.
E-103
To turn Power Saving on or off
1. In the Timekeeping Mode, pull out the crown.
2. Press
B
six times. This will cause
P.SAVE
to appear on the digital
display, along with the fl ashing current Power Saving setting (
ON
or
OFF
).
3. Rotate the crown to select either on (
ON
) or off (
OFF
) for the Power
Saving setting.
4. Push the crown back in.
Operation Guide 5365
… 13

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Casio 5365 - PRW-6000 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Casio 5365 - PRW-6000 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,97 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Casio 5365 - PRW-6000

Casio 5365 - PRW-6000 Gebruiksaanwijzing - Deutsch - 15 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info