544010
23
Verklein
Vergroot
Pagina terug
1/290
Pagina verder
English | 23
Bosch Power Tools 1 609 92A 0MW | (28.2.14)
Pour the spray material into the container 7 up to no more
than the 1000 mark.
Carry out a test-spray run on a test surface. (see “Spray-
ing”, page 23)
When the spraying pattern is perfect, start the spray job.
or
When the spraying result is not satisfactory or when no paint
comes out, please continue as described under “Correction of
Malfunctions” on page 25.
Starting Operation
Observe the mains voltage! The voltage of the power
source must correspond with the data on the type plate of
the machine.
Pay attention that the base unit cannot draw in dust or
other contamination during operation.
Make sure never to spray on the base unit.
Stop spraying if fluid escapes from places other than
the intended nozzle during spraying, and restore the
spray gun to its proper condition. There is a risk of elec-
tric shock.
Do not direct the fine-spray system against yourself,
other persons or animals.
Switching On (see figure D)
To save energy, only switch the fine-spray system on when
you are using it.
Check whether the correct nozzle cap is mounted (see
“Changing the Nozzle Cap”, page 22).
Plug the mains plug into a socket outlet.
Grasp the spray gun by the handle and point it at the spray
surface.
Switch on by pressing the on/off button 25.
Set the on/off button 25 to the required application to reg-
ulate the air flow (see also “Adjusting the Air Flow”,
page 24).
Pull the trigger switch 5 on the spray gun.
Note: When the base unit is switched on, air always flows out
at the nozzle .
Switching Off
Let go of the trigger switch 5 and switch off by pressing the
on/off button 25.
Pull the mains plug from the socket outlet.
Working Advice
Spraying (see figures E H)
Note: Observe the wind direction when operating the power
tool outdoors.
Firstly, carry out a test-spray run and adjust the spray pat-
tern and the spray material quantity according to the spray
material. (For adjustments, see the following sections)
Be absolutely sure to hold the spray gun at a consistent dis-
tance of 20 –25 cm perpendicular to the spray object.
Begin the spraying procedure outside the target area.
Move the spray gun evenly cross-wise or up-and-down, de-
pending on the spray pattern setting.
An even surface quality is achieved when the paths overlap
by 4 5cm.
When spraying horizontal objects or spraying overhead,
hold the spray gun at a slight angle and back away from the
sprayed surface.
Risk of stumbling! Pay attention to possible obstacles
in the room.
Avoid interruptions within the spray surface.
Guiding the spray gun evenly will provide uniform surface
quality.
Non-uniform clearance and spray angle lead to heavy forma-
tion of paint mist and thus to an uneven surface.
End the spraying procedure outside the target area.
Never completely empty the container for the spray material
by spraying. If the suction tube is no longer immersed in the
spray material, the spray jet will be interrupted and this will
result in an inconsistent surface.
If spray material settles on the air cap 2 or the nozzle cap,
clean the components with the supplied cleaning brush 28.
Adjusting the Spray Pattern (see figure I)
Never actuate the trigger switch 5 while adjusting the
air cap 2.
–Turn the air cap 2 to the requested position.
Adjusting the Spraying Capacity (see figure J)
(PAINTVolume)
Turn the thumbwheel 4 to set the required spraying capac-
ity:
Settings 1/2/3: “wood/glaze/lacquer” application,
Settings 4/5: “wall” application.
Put the spray gun on the container 7. Turn the con-
tainer 7 towards the close symbol until you hear the
lock ring 6 engage.
Air cap Spray jet pattern Application
Vertical flat jet for
horizontal working
direction
Horizontal flat jet
for vertical working
direction
Round jet for cor-
ners, edges and
hard to reach loca-
tions
OBJ_BUCH-2026-002.book Page 23 Friday, February 28, 2014 11:28 AM
23

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Bosch-PFS-5000-E

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bosch PFS 5000 E bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bosch PFS 5000 E in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Turks, Deens, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 59,44 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info