544010
25
Verklein
Vergroot
Pagina terug
1/290
Pagina verder
English | 25
Bosch Power Tools 1 609 92A 0MW | (28.2.14)
If required, clean the filling sieve 13 thoroughly with dilut-
ing agent.
Before mounting, allow all components to dry thoroughly.
Reassemble the fine-spray system in reverse order.
Cleaning the Air Filter (see figure N)
The air filter 30 must be cleaned occasionally. The air filter
must be replaced if it is heavily soiled.
Open the air filter cover 29.
Remove the air filter 30.
Light soiling:
Tap the air filter 30 to empty it.
or
Heavy soiling:
Clean the air filter 30 under running water and then leave it
dry thoroughly to prevent mould from forming.
or
Replace the air filter 30.
Reinsert the air filter.
Close the air filter cover 29 again.
Material Disposal
Diluting agent and remainders of spray material must be dis-
posed of in an environmentally-friendly manner. Observe the
manufacturer’s disposal information and the local regulations
for disposal of hazardous waste.
Chemicals harmful to the environment may not be disposed
of into soil, groundwater or bodies of water. Never pour
chemicals harmful to the environment into the sewerage sys-
tem!
Correction of Malfunctions
Problem Cause Corrective Measure
Spray material does not cover
properly
Spraying capacity too low Turn the thumbwheel 4 towards setting 5
Clearance to target area too large Reduce spray distance
Not enough spray material on target area,
too few spray paths sprayed over target area
Apply more spray paths over target area
Spray material too viscous Dilute the spray material again and carry out
a test-spray run
Spray material runs off after
coating
Too much spray material applied Turn the thumbwheel 4 towards setting 1
Clearance to target area too close Increase spray distance
Viscosity of spray material too low Add original spray material
Spray material applied too often over same
spot
Remove spray material; reduce number of
spray paths over same spot
Atomisation too coarse
Spraying capacity too high Turn the thumbwheel 4 towards setting 1
Air flow too low Turn the air flow control 25 to the right
White nozzle cap 10 mounted (nozzle diam-
eter too large)
Mount the grey nozzle cap 11 or the black
nozzle cap 12
Nozzle needle 15 soiled Clean nozzle needle
Spray material too viscous Dilute the spray material again and carry out
a test-spray run
Air filter 30 heavily soiled Changing the Air Filter
Excessive paint mist
Too much spray material applied Turn the thumbwheel 4 towards setting 1
Air flow too high Turn the air flow control 25 to the left
Clearance to spray surface too large Reduce spray distance
Spray jet pulsates
Not enough spray material in container Refill spray material
Ventilation hole 18 on suction tube 17
clogged
Clean the suction tube and the ventilation
hole
Suction tube 17 loose Insert suction tube properly
Nozzle cap 10/11/12 loose Tighten the nozzle cap 10/11/12
Air filter 30 heavily soiled Changing the Air Filter
Spray material too viscous Dilute the spray material again and carry out
a test-spray run
OBJ_BUCH-2026-002.book Page 25 Friday, February 28, 2014 11:28 AM
25

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Bosch-PFS-5000-E

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bosch PFS 5000 E bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bosch PFS 5000 E in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Turks, Deens, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 59,44 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info