572349
37
Verklein
Vergroot
Pagina terug
1/40
Pagina verder
Trouble-Shooting Guide
(valid for all LCD Intelligent Dialogue WAL..... models)
Depending on the model, your
washing machine is equipped
with various automatic safety
functions. This enables faults to
be detected in good time and
the safety system can react
appropriately.
These faults are frequently so
minor that they can be
removed within a few minutes.
The appliance will not
start, no display is visible.
Check whether:
The mains plug is inserted
into the socket;
The wall socket is functioning
correctly (use a table lamp or
similar to test).
The On/Off button has
been pressed and the
washing machine is switched
on.
The washing machine will
not start and the Start
light is flashing.
An acoustic signal sounds and
the notice Door Open!
appears in the display:
Close the door (child safety).
The washing machine
stops shortly after the
programme start.
An acoustic signal sounds and
the notice No Water Supply
appears in the display.
Switch the washing machine
off, pull out the mains plug and
check whether:
The tap is fully turned on;
The water supply pressure is
sufficient;
The water supply hose is
kinked;
The mesh filters are blocked
(see Care and Maintenance/
Mesh filter in the water
connection);
The water in the inlet hose is
frozen;
The washing machine has a
safety hose and the safety
valve is open (red indicator in
the safety valve inspection
window); In this case replace
it with a new safety hose.
Reconnect the appliance to the
electrical socket. Switch the
washing machine on and restart
the desired programme (do not
add any more detergent).
The washing machine
stops during the
programme and the
Start light flashes.
Check whether:
Rinse Hold Selected
appears in the display.
The door has been opened.
Close the door.
Press the Start button to
continue with the programme.
Detergent and additive
product residues in
dispenser at end of wash.
Check whether:
The siphon is correctly
installed and clean (see Care
and Maintenance);
Enough water is being
supplied. The mesh filters
could be clogged (see Care
and Maintenance/Mesh filter
in the water connection).
When using powder
detergent beforehand, the
coloured insert for dosing
liquid detergent has been
removed from the dispenser
.
The washing machine
vibrates during the spin
cycle.
Check whether:
The washing machine is
standing horizontal and even
on all four feet (see
Installation/Adjust the
feet);
The transport bolts have been
removed. The transport bolts
must be removed before using
the washing machine (see
Installation/Remove the transit
bolts).
Final spin results are poor:
Check whether the notice Load
Imbalance or Overdosing
appears on the display.
The washing machine has an
imbalance detection and
correction system. If individual
heavy items are loaded (a
bathmat, bathrobe), this system
may reduce the spin speed
automatically or even interrupt
the spin completely if it detects
too great an imbalance even
after several spin starts, in order
to protect the washing
machine.
If the laundry is still too wet at
the end of the cycle, add
smaller articles of laundry and
repeat the spin cycle.
Excessive foam formation
may prevent spinning.
Observe correct detergent
dosing.
Check whether:
Spin speed 0 has been
selected.
37

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bauknecht WA 89890 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bauknecht WA 89890 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,7 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Bauknecht WA 89890

Bauknecht WA 89890 Gebruiksaanwijzing - Deutsch - 40 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info