572349
34
Verklein
Vergroot
Pagina terug
1/40
Pagina verder
Trouble-Shooting Guide
(Valid for all models except LCD Intelligent Dialogue
WAL....)
Depending on the model, your
washing machine is equipped
with various automatic safety
functions. This enables faults to
be detected in good time and
the safety system can react
appropriately. These faults are
frequently so minor that they
can be removed within a few
minutes.
The appliance will not
start, no lamp lights up.
Check whether:
the mains plug is inserted
into the socket;
the wall socket is functioning
correctly (use a table lamp or
similar) to test);
The washing machine will
not start... (varies according
to model) and the Start/
Pause light flashes.
Check whether:
the appliance door is
properly closed (child safety);
the Start/Pause button has
been pressed.
...and the Start/Pause
light goes on (for models
with a digital display a dash
appears here).
Check whether:
a programme has been
selected.
...and theOn/Off lamp
goes on.
Check whether:
the appliance door is
properly closed (child safety);
the tap is turned on (see also
Fault in the water supply/
safety hose);
a programme has been
selected.
The washing machine
stops during the
programme (varies
depending on model).
Check whether:
The Rinse Hold light
flashes, or the Rinse Hold
button has been pressed;
terminate this special option
by pressing the button;
Another programme has
been selected and the Start/
Pause button is flashing.
Reselect the desired
programme and press the
Start/Pause button;
The door has been opened
and the Start/Pause light is
flashing. Close the door and
press the Start/Pause
button again;
The On/Off button has
been pressed and the light is
on;
The washing machine safety
system has been activated
(see Fault Indicators table).
Detergent and additive
product residues in
dispenser at end of wash.
Check whether:
the siphon is correctly
installed and clean (see Care
and Maintenance);
sufficient water is entering.
The mesh filters in the water
connection could be blocked
(see Care and
Maintenance);
When using powder
detergent beforehand the
coloured insert for dosing
liquid detergent has been
removed from the
dispenser.
The washing machine
vibrates during the spin
cycle.
Check whether:
the washing machine is
standing horizontal and even
on all four feet (see
Installation/Adjusting the
feet);
The transport bolts have
been removed. Before using
the washing machine, the
transport bolts must be
removed (see Installation/
Remove the transit bolts).
Final spin results are poor.
The washing machine has an
unbalance detection and
correction system. If individual
heavy items are loaded (a
bathmat, bathrobe), this system
may reduce the spin speed
automatically or even interrupt
the spin completely if it detects
too great an imbalance even
after several spin starts, in order
to protect the washing
machine.
If the laundry is still too wet
at the end of the cycle, add
smaller articles of laundry to
balance the load and repeat
the spin cycle.
Excessive foam formation
may prevent spinning.
Observe correct detergent
dosages.
Check whether:
Spin speed 0 has been
selected.
34

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bauknecht WA 89890 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bauknecht WA 89890 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,7 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Bauknecht WA 89890

Bauknecht WA 89890 Gebruiksaanwijzing - Deutsch - 40 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info