478500
59
Verklein
Vergroot
Pagina terug
1/76
Pagina verder
Page 57FT-897D OPERATING MANUAL
MENU MODE No015
[
CAR LSB R
]
Function: Sets the Rx Carrier Point for LSB.
Available Values: –300 ~ +300 Hz
Default: 0 Hz
MENU MODE No016
[
CAR LSB T
]
Function: Sets the Tx Carrier Point for LSB
Available Values: –300 ~ +300 Hz
Default: 0 Hz
MENU MODE No017
[
CAR USB R
]
Function: Sets the Rx Carrier Point for USB
Available Values: –300 ~ +300 Hz
Default: 0 Hz
MENU MODE No018
[
CAR USB T
]
Function: Sets the Tx Carrier Point for USB
Available Values: –300 ~ +300 Hz
Default: 0 Hz
MENU MODE No019
[
CAT RATE
]
Function: Sets the transceivers circuitry for the CAT baud
rate to be used.
Available Values: 4800bps/9600bps/38400bps
Default: 4800bps
MENU MODE No020
[
CAT/LIN/TUN
]
Function: Selects the device which is connected to the
CAT/LINEAR jack on the rear panel.
Available Values: CAT/LINEAR/TUNER
Default: CAT
MENU MODE No021
[
CLAR DIAL SEL
]
Function: Defines the “control” knob to be used for setting
of the clarifier offset frequency.
Available Values: CLAR, M/V, MAIN (Clarifier/Selector/
Main Dial Knobs)
Default: CLAR
MENU MODE No-022
[
CW AUTO MODE
]
Function: Selects whether the KEY jack shall be “Enabled”
or “Disabled” while using the SSB/FM modes.
Available Values: ON/OFF
Default: OFF
OFF: The KEY jack is enabled on the CW mode only.
ON: The KEY jack is enabled on all modes (SSB mode:
A1, FM mode: F2). Thus, on SSB, you can ask a
station for a CW QSO without having to change your
FT-897Ds Mode selection, if Menu #022 is set to
“On.”
MENU MODE No023
[
CW BFO
]
Function: Sets the CW carrier oscillator injection side on
the CW mode.
Available Values: USB/LSB/AUTO
Default: USB
USB: Injects the CW carrier oscillator on the USB side
LSB: Injects the CW carrier oscillator on the LSB side
AUTO:Injects the CW carrier oscillator on the LSB side
while operating on the 10 MHz band and below, USB
side while operate on the 10 MHz band and up.
MENU MODE No-024
[
CW DELAY
]
Function: Sets the receiver recovery time during pseudo-
VOX CW semi-break-in operation.
Available Values: FULL/30 ~ 3000 msec
Default: 250 msec
The recovery time may be adjusted in steps of 10 msec. A
longer delay may be preferable if you pause frequently while
sending.
MENU MODE No025
[
CW KEY REV
]
Function: Sets the keyer paddle’s wiring configuration.
Available Values: NORMAL/REVERSE
Default: NORMAL
NORMAL: Keyer paddle polarity is normal. The “tip” plug
connection produces dots, and the “ring” plug
connection produces dashes.
REVERSE: Keyer paddle polarity is inverted. The “tip”
paddle produces dashes, and the “ring” paddle
produces dots.
MENU MODE No026
[
CW PADDLE
]
Function: Enables/disables CW keying by the microphone’s
[UP]/[DWN] keys.
Available Values: ELEKEY/MICKEY
Default: ELEKEY
When this Menu Item is set to “MICKEY,” press the
microphone’s [UP] key to send a “dot,” and press the
microphone’s [DWN] key to send a “dash” (while the built-
in electronic keyer is engaged).
MENU MODE No-027
[
CW PITCH
]
Function: Setting of the pitch of the CW sidetone, BFO
offset, and CW filter center frequencies.
Available Values: 400 ~ 800 Hz
Default: 700 Hz
The CW pitch may be adjusted in steps of 100 Hz.
MENU MODE No028
[
CW QSK
]
Function: Selects the time delay between when the PTT is
keyed and the carrier is transmitted during QSK operation
when using the internal keyer.
Available Values: 10/15/20/25/30 ms
Default: 10 ms
Note: If you select “25 (or 30) ms,” please do not attempt
to set Menu [No-030 CW SPEED] to a speed faster than
“50 (42) wpm,” as the delay will make it impossible to trans-
mit.
MENU MODE No-029
[
CW SIDE TONE
]
Function: Setting of the CW sidetone volume level.
Available Values: 0 ~ 100
Default: 50
MENU OPERATION
59

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yaesu FT-897D bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yaesu FT-897D in de taal/talen: Engels als bijlage per email.

De handleiding is 3,3 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info