674722
45
Verklein
Vergroot
Pagina terug
1/56
Pagina verder
DR-2X / DR-2XE Operating Manual 43
Pin No Pin Name I/O Descriptions
1 EXT I/O Input
[
L
]
GND: Remote mode
[
H
]
OPEN: Repeater mode
2 PTT Input
[
L
]
GND: EXT PTT ON
[
H
]
OPEN: EXT PTT OFF
When this pin is pulled low by an external device, it keys the repeater
transmitter.
On signaling while controlling the external PTT:
Pin 6 (TONE IN) ... Valid
Pin 7 (AF IN) ... Invalid
3
CTCSS/DCS
(PKSQL)
Output
[
L
]
GND: Decoded
[
H
]
OPEN: Undecoded
Signaling settings in the repeater setup menu will be applied.
4
SQL DET
(Noise SQL)
Output
[
L
]
GND: SQL open
[
H
]
OPEN: SQL close
This is an open-collector, active-low output capable of sinking about 10
mA. It indicates that the receiver squelch is open. If the squelch control is
properly set, this indicates a carrier on the receiver channel.
5 GND GND Chassis ground for all logic levels and power supply return
6
TONE IN Input
CTCSS/DCS EXT input / 600 ohm, 500 mV peak to peak
Valid during external PTT control
This pin is sub-audible tone input, and has a flat response characteristic
(repeater deviation is constant for a given signal level over the frequency
range of 5 ~ 250 Hz). Injecting a too high signal level here causes over-
deviation of CTCSS or DCS, degrading performance.
Use shielded cable to connect to this pin, connecting the shield to GND.
7 AF IN Input
EXT Modulation input / 600 ohm, 1.5 V peak to peak
Valid during external PTT control
This pin is audio input (300 ~ 3,000 Hz). This audio is injected before the
splatter filter stage, so excess signal input levels are clipped.
It is impossible to input analog modulation signals and convert them to
digital signals on DR-2X/DR-2XE.
Use shielded cable to connect to this pin, and connect the shield to GND.
To use the external AF input, set the Pin11/Pin12 EXT port setting to RX: Auto
(AMS) / TX: FM (FIX).
8 DISC OUT Output
Up-link RX DISC output (w/o de-emphasis), 500 mV peak to peak
Discriminator output during up-link reception. Does not affect the operation
mode of the repeater.
Received signals with standard deviation produce 500 mVp-p audio (300
- 3,000 Hz) are output at this pin. The signal is extracted before the de-
emphasis and squelch circuitry. Use shielded cable to connect to this pin,
and connect the shield to GND.
9 AF OUT Output
Up-link RX AF output (w/ de-emphasis), 300 mV peak to peak
Analog audio output during up-link reception. Does not affect the operation
mode of the repeater.
This pin is an output for AF signal (300 mVp-p), being extracted after the
de-emphasis.
Demodulated digital signals can be output as well.
10 GND GND Chassis ground for all logic levels and power supply return
11 EXT port 1
ø
Input
In Remote mode, the logic combination of Ports 1 and 2 determines the
transmit and receive modes as below:
Port 1 Port 2 RX TX
H H Auto (AMS) Digital
L H Digital Digital
H L Auto (AMS) FM (FIX)
L L Auto (AMS) Auto (AMS)
12 EXT port 2
ø
Input
13 EXT port 3
ø
Input
[
L
]
GND: RX Tone OFF
[
H
]
OPEN: Setup mode
Input a low level signal to indicate that the receiving tone is invalid.
14
EXT port 4
ø
Input
[
L
]
GND: TX Tone OFF
[
H
]
OPEN: Setup mode
Input a low level signal to indicate that the transmitting tone is invalid.
15 VCC VCC
Power supply
This pin provides 13.8V, 2.0A, DC from the repeater supply. There is an
internal 3 A fuse to prevent damage to the repeater.
ø
These functions may only be activated while the repeater is in Remote mode.
45

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yaesu DR-2X bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yaesu DR-2X in de taal/talen: Engels als bijlage per email.

De handleiding is 14,18 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info