5019 300 02292
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” next page.
START/RESUME
BUTTON
Push this button to start the
selected program: the indicator
lights up and goes off at the end
of the program.
When the door is opened
during a washing cycle, the
cycle is temporarily paused:
the Start indicator blinks.
To resume the cycle close the
door and push Start button
again.
CANCEL/OFF BUTTON
Push this button to switch off
the control panel.
If pressed when a program is
running it cancels the program
ongoing draining water for 1
minute (0:01 is shown into the
display).
If pressed when the dishwasher
is switched off, it drains any
possible liquids from
dishwasher (1 minute process).
DELAYED START
BUTTON
Push the button (repeatedly) to
delay the start of the program -
delay indicator turns on.
Adjustable from 1 to 24 hours.
With each press of the button,
the delay increases by one hour
and after "h 24" returns to
"h 00”. When this option is
selected the delay indicator
turns on. Then press the
START button. The
dishwasher will start after the
set time.
POWER CLEAN
Thanks to the additional
power jets this option provides
a more intensive and powerful
wash in the lower rack, in the
specific area. This option is
recommended for washing
pots and casseroles (see page
7). Press this button to activate
Power Clean (the indicator
lights up).
TABLET SETTING
This setting allows to optimize
the cycle performances
according the type of detergent
used. Push the Tablet button
for 3 seconds (until the
indicator lights up) if you are
using the combined detergents
in tablet (rinse aid, salt and
deteregent in 1 dose). If you
are using powder detergent or
liquid detergent, the Tablet
indicator on the control panel
has to be off.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start”
selected it indicates the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if...”.
