17
Commissioning the Mover
1. Ensure the battery used to operate the Mover is fully
charged (do not operate the Mover if the voltage in the battery
is below 10.2 V DC).
2. Place the caravan outside in a clear area and pull on the
handbrake. Ensure that the rollers are disengaged from the
road tyres and the corner steadies are raised.
3. Connect battery terminals to battery, check that all cables
are secure and not hot or indicating signs of short circuits, etc.
4. Press the red button on the remote control twice within one
second. This switches the remote control on and the LED illu-
minates. If LED does not illuminate, check polarity and condi-
tion of batteries in remote control. The remote control switches
itself off after about 40 seconds if no buttons are pressed.
5. Check that both drive motors are stationary. With the hand-
set switched on, and within 2 m of the control unit, press the
forward button. Check that both drive motors are driven.
6. Press the red button again to switch off the handset and
Mover.
7. Engage the drive rollers by use of the 19 mm AF wrench
provided or the steady leg brace. The action will be quite stiff
and will snap into place. The movement required is just over
1/2 turn. Turn the wrench until it will turn no more without
excessive force. do this on both sides of the caravan.
8. Ensure that there no obstacles around the caravan, release
the handbrake and switch the remote control on. Now check
all functions several times according the operating instructions.
9. Press the red button again to switch the handset and Mover
off. Release the drive mechanisms with the wheel brace (19 mm)
and recheck the roller to tyre spacing. Adjust if necessary.
The distance between the rollers and the tyres is 20 mm.
Technical Data
Designation: Caravan Mover II
Euro Mover II
Area of operation: Single axle caravans with a
total weight up to 1700 kg
Operational voltage: 12 V DC
Current consumption: Average 15 A
Maximum 120 A
Stand by consumption: < 15 mA
Speed: approx. 22 cm per second
(depending of the tyre size)
Maximum tyre width: 205 mm
Weights: Caravan Mover II, approx. 30 kg
Euro Mover II, approx. 32 kg
Right to effect technical modifications reserved!
Manufacturer’s terms of warranty
1. Case of warranty
The manufacturer grants a warranty for malfunctions in the ap-
pliance which are based on material or production faults. In ad-
dition to this, the statutory warranty claims against the seller
remain valid.
A claim under warranty shall not pertain:
– for parts subject to wear and in cases of natural wear and
tear
– as a result of not original Truma parts being used in the
appliance
– as a consequence of failure to respect the manufacturers
instructions for installation and use
– as a consequence of improper handling
– as a consequence of improper transport packing.
2. Scope of warranty
The warranty is valid for malfunctions as stated under item 1,
which occur within 24 months after conclusion of the pur-
chase agreement between the seller and the final consumer.
The manufacturers will make good such defects by subse-
quent fulfilment, i.e. at their discretion either by repair or re-
placement. In the event of manufacturers providing service un-
der warranty, the term of the warranty shall not recommence
anew with regard to the repaired or replaced parts; rather, the
old warranty period shall continue to run. More extensive
claims, in particular claims for compensatory damages by pur-
chasers or third parties, shall be excluded. This does not affect
the rules of the product liability law.
The manufacturer shall bear the cost of employing the Truma
customer service for the removal of a malfunction under war-
ranty – in particular transportation costs, travelling expenses,
job and material costs, as long as the service is carried out by
an authorised Truma-Dealer.
Additional costs based on complicated removal and installation
conditions of the appliance (e.g. removal of furniture or parts
of the vehicle body) do not come under warranty.
Rollers carry 24 months warranty against manufacturing de-
fects. Rollers are, like the tyres on your caravan a consumable
item and the grit will eventually wear down. Also, the grit can
be damaged by sharp stones becoming embedded in your
caravan tyre: take care to remove sharp stones from your tyres
prior to using your Mover.
3. Raising the case of warranty
In the event of faults, in principle the Truma Service Centre is
to be notified: Truma Gerätetechnik GmbH & Co. KG,
Wernher-von-Braun-Straße 12, D-85640 Putzbrunn.
In other countries, respective service partners are available
(refer to address list). Complaints must be specified. In addi-
tion, the correctly completed warranty certificate must be pre-
sented or the Serial number of the appliance and the date of
purchase specified.
In order for the manufacturers to be able to determine whether
an incident subject to warranty has occurred, the end user
must, at his own risk, bring the device to the manufacturers or
send it to them.
In instances of the device being sent to the works, dispatch is
to be effected by freight transport. In cases under warranty, the
works shall bear the transport costs or the costs of delivery
and return. If the damage is deemed not to be a warranty case,
the manufacturer shall notify the customer and shall specify re-
pair costs which shall not be borne by the manufacturer; in this
case, the customer shall also bear the shipping costs.
