586467
39
Verklein
Vergroot
Pagina terug
1/46
Pagina verder
9. Pull the rear wheel assembly rear-
ward.
NOTE: Never depress the rear brake
pedal with the rear wheel removed. It
is very difficult to force the pads back
into the caliper assembly.
10.
To replace the wheel reverse the
complete sequence listed.
11.
(Only for Canada) Replace the
cotter pin with a new one.
12.
After installing the wheel, apply the
brake several times and then
check that the wheel rotates freely.
A WARNING
Failure to adjust the drive chain and
failure to torque bolts and nuts
properly could lead to an accident.
Adjust the drive chain as de-
scribed in DRIVE CHAIN AD-
JUSTMENT section after install-
ing the rear wheel.
Torque bolts and nuts to the
proper specifications. If you are
not sure of the proper procedure,
have your
authorized
SUZUKI
dealer or qualified mechanic do
this.
Rear axle nut tightening torque:
100
N-m
(10.0
kgf-m,
72.5
Ib-ft)
A WARNING
Failure to extend brake pads after
installing
the wheel can cause poor
braking performance and may re-
sult in an accident.
Before riding, "pump" the brake re-
peatedly until brake pads are
pressed against the brake disks
and proper lever/pedal stroke and
firm feel are restored. Also check
that the wheel rotates freely.
LIGHT BULB REPLACEMENT
The wattage rating of each bulb is
shown on the table below. When re-
placing a burned out bulb, always use
the exact same wattage rating. Using
other than the specified rating can re-
sult in overloading the electrical sys-
tem or premature failure of a bulb.
A CAUTION
Using a light
bulb
with the wrong
wattage rating can cause electrical
system damage or shorten bulb
life.
Always use the specified light bulb.
Headlight
Position light
Turn signal light
Brake
light/
Taillight
License plate light
12V65W(HB3)
... High beam
12V55W(H7)
... Low beam
12V5W*
12V
21W
12V
21/5W
x 2
12V
5W
* Except for Canada and Australia
HEADLIGHT
To replace the headlight bulb, perform
the following step:
Remove the cover ® by removing the
fasteners
@
(right and left).
High beam
1. Turn the socket © counterclock-
wise and remove it.
2. Disconnect the coupler.
Low beam
1.
Disconnect the socket ® from the
headlight and remove the rubber
cap®.
2. Unhook the bulb holder spring (3)
and pull out the bulb @.
A CAUTION
Oil from your skin may damage the
headlight bulb or shorten its life.
Grasp the new bulb with a clean
cloth.
74
75
vi
39

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Suzuki GSX 1300R 2001 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Suzuki GSX 1300R 2001 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,11 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info