733469
5
Verklein
Vergroot
Pagina terug
1/24
Pagina verder
Page 3 of 20
BIKE SETUP SPECIFICATIONS
Seatpost height
SEATPOST MINIMUM INSERTION
1
: To prevent damage to the frame, it’s important to have a
minimum amount of seatpost in the seat tube.
Carbon frames:
Small / Medium: minimum 70mm insertion Large / X-Large: minimum 100mm insertion
Aluminum frames:
Certain frames are equipped with a sight hole, which is a small hole located approximately 70-
100mm below the seat collar (fig.1). The sight hole must not be confused with the seat collar slot
(fig.1), which is a narrow slot (approx 1-1.5” long) that extends down from the top of the seat tube to
allow the frame to tighten around the seat post.
If your frame is equipped with a sight hole on the seat tube, the seat post MUST be visible through
the sight hole, AND the seat post must NOT project from the frame beyond the min/max mark. Use
the sight hole in conjunction with the min/max mark on the seat post. If the seat post is at the min/
max mark and the seat post is not visible through the sight hole (frames equipped with a sight hole),
the seat post is not inserted deeply enough into the seat tube and should be lowered until it can be
seen through the sight hole. Do NOT cut the seat post short!
If your seat post is at the min/max mark and/or the seat post is not visible through the sight hole
(frames equipped with a sight hole) and the saddle is not high enough, the seat post must be
replaced with a longer seat post.
WARNING! If your seatpost is not inserted deep enough into the seat tube, the seatpost
may break, which could cause you to lose control and fall.
NOTE: When running a saddle in a low position, it’s important to fully compress the rear end
of the bicycle to ensure that the tire doesn’t contact the saddle. This is especially important on
longer travel bicycles.
Demo Carbon: Minimum insertion depth (all sizes): 100mm.
Refer to the Specialized Bicycle Owner’s Manual for additional seatpost insertion information.
Frame linkage assembly
Specialized recommends following a specific order when assembling the rear triangle pivot locations
of FSR suspension bike models
2
.
A. Main pivot
B. Main link pivot
C. Horst link or link @ seatstay pivot
D. Lower shock eye or yoke pivot
E. Upper shock eye
Assembling the upper or lower pivots of the seatstay as a last step makes it easier to align the parts
and hold the washers in place.
Down tube cable guide installation
Certain Specialized FSRs are equipped with bolt-on down tube cable guides
3
under the down
tube (3- or 4-cable bats). For proper housing placement and function, the hydraulic rear brake
housing goes in the larger (non-drive-side) inner slot, while the gear cables (4mm only) go on the
outside.
Telescoping seatposts with internal routing require the 4-cable bats, with the cable (4mm only) going
in the narrower (drive-side) inner slot.
A. Blue: Gear (narrow outer slots)
B. Red: Brake (larger inner slot)
C. Green: Seatpost (narrower inner slot)
D. Triple or Quad bat rubber base (standard)
E. Triple or Quad bat rubber base (extended)
F. Triple or Quad bat alloy holder
G. Drive-side
H. Non-drive-side
I. Seatpost housing entry port
J. Down tube
NOTE: Stumpjumper Carbon / Enduro models use 2 x
D
and 1 x
E
. Stumpjumper Alloy /Camber Alloy models use 3 x
D
.
Do not overtighten the guide bolts! Too much pressure can squeeze the cable housings, creating friction and poor shifting for the cables.
Torque: 30 in-lbf (3.4 Nm).
Status models: The housings are routed on top of the down tube.
142+ rear axle
Certain Specialized bike models are equipped with a 142+ rear axle system, which requires the use of a proprietary Specialized 142+ wheel, or a 142mm
compatible wheel. For additional information regarding compatibility, please refer to the Roval Hub Compatibility Guide at www.specialized.com.
Accessories
Specialized offers replacement chainstay protectors for most FSR models, available through your Authorized Specialized Dealer.
E
B
C
D
C
A
2
QUAD BAT TRIPLE BAT
3
A A A ABB
DD
EE
C
FF
G G
I
J J
H H
1
seat collar slot
Sight hole
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Specialized FSR - 2015 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Specialized FSR - 2015 in de taal/talen: Engels als bijlage per email.

De handleiding is 14,03 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info