718540
18
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
1- Raise take-up lever to its highest position by turning hand wheel
toward you. Raise presser foot.
2- Place spool on spool pin as shown, with thread coming from the back
of the spool.
3- Draw thread into thread guide using both hands.
4- Draw thread down into the tension area and around the check spring
holder.
5- Fimly draw thread up and through take-up lever from right to left.
6- Then draw thread down and slip it into the lower thread guide.
7- Draw thread down and slip it into needle bar thread guide.
Thread needle eye from front to back.
- NOTE: You may want to cut the end of thread with sharp scissors for
easier needle threading.
Drawing up bobbin case:
1-Raise the presser foot and hold the needle thread lightly with you left
hand.
2-Turn the hand wheel slowly towards you with your right hand until the
needle goes down and continue turning the hand wheel until the take-up
lever is at its highest position. Lightly draw up the needle thread forming
a loop of the bobbin thread.
3-Pull 15cm (6 inches) of both thread back and under the presser foot.
Balancing needle thread tension:
- The needletop thread and the bobbin thread should interlock in the
center of two layers of fabric in straight seams.
- Set the desired number of the thread tension dial at setting mark.
- Tighten the needle thread tension by moving the dial to a higher
number.
- Loosen the needle thread tension by moving the dial to a lower num-
ber.
- NOTE: In order to obtain better zigzag stitches, the upper thread
tension should be slightly weaker than the bobbin thread tension. That
means, the upper thread should appear slightly on the reverse side of
the fabric, but the bobbin thread cannot appear on the top side of the
fabric.
Reverse stitch button:
- As long as you are pressing down this lever while sewing, the machine
will continue to feed the fabric backwards.
Seam guide line
- The numbers on the needle plate indicate the distance between the
center needle position and the line.
- The numbers in the front indicate in Millimeters.
- The numbers in the back indicate in inches.
Dropping the feed dogs:
18

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Solac SW8240 - Cotton 24.0 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Solac SW8240 - Cotton 24.0 in de taal/talen: Engels, Frans, Portugees, Spaans als bijlage per email.

De handleiding is 7,49 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info