613882
5
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
2.
3.
Renusol ConSole · EN · 04/2011 — 5
A
h
B
ASSEMBLY PREPARATION
Calculating the amount of ballast for the
ConSole
The wind loads acting on the ConSole re-
quire it to be weighed down with ballast.
Gravel, stones, plates and similar materials
are suitable as ballast.
The table opposite can serve as a guide for
the required ballast. These values are calcu-
lated according to DIN 1055-4:2005-03 and
Eurocode. Several years experience confirm
the reliability of the system.
The exterior module series and column re-
quire more ballast according to the table.
The values indicated prevent the ConSoles
from tipping over, sliding or being lifted-
ConSoles.
In order to ensure safety against sliding, the
coefficient of friction between the roofing
and the ConSole must be greater than 0.6 .
This can be established using a spring
scale. A ConSole filled with 100 kg of ballast
should only move from the spring scale
under a horizontal tensile force of over
60 kg.
Additional ballast
In a higher wind load zone: 30% more bal-
last per level.
When using extension rails: 10% more bal-
last.
In case of excess length of the modules on
the side:
additional ballast in proportion to the excess
length.
Calculation basis
The ballast values are calculated for wind
load zone 1 for Germany according to DIN
1055-4:2005-03 and for terrain category III:
Suburbs, industrial or commercial zones and
forests.
*The system weight is not included in the
recommended ballast values.
Recommended ballast values for ConSoles in kg in terrace systems*
A = minimum distance of the ConSolen series:
ConSole 4.1 >1.2 m
ConSole 4.2/5.2/6.2 >1.5 m
B = minimum
roof edge > 1/5 h
h = Building height
Schematic diagram of a ConSole terrace system
Distances between rows on the ConSole system
Positioning the ConSoles
Check whether the installation surface
(e.g., the roof) is enough for the additional
roof load.
The surface must be level, clean and not
too slippery. With slippery surfaces, e.g.,
with PVC roof membranes, an anti-slip mat
should be used, e.g., a building protection
mat.
Place the ConSole with the opening facing
south. A minimum distance of a fifth of the
building height "h" should be maintained
from the side of the roof. Building height 10
metres => minimum distance 2 metres.
The minimum distance between
the ConsSoles is clear from the schematic
diagram.
Filling ballast
Now fill in the correct ballast. Reference
values here are contained in the table
"Recommended ballast values" at the top
of this page.
Ballast diagrams for all ConSole types are
available on our website
www.renusol.com/download as a PDF le.
inner ConSoles
in the slipstream
circular,
non-binding
roof area
outer,
wind-exposed
ConSoles
Roof edge
Building height
Up to 8 meters Up to 12 meters Up to 16 meters
interior exterior interior exterior interior exterior
ConSole 4.1 62 99 73 115 82 128
ConSole 4.2 58 94 68 110 77 122
ConSole 5.2 63 106 75 123 84 137
ConSole 6.2 83 134 98 156 110 173
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Renusol ConSole bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Renusol ConSole in de taal/talen: Engels als bijlage per email.

De handleiding is 1,58 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info