POWX1388 EN
Copyright © 2021 VARO 2 www.varo.com
Unplug the adapter when not in use and store it in a suitable storage cabinet.
Avoid charging your battery in freezing conditions as charging power will not be sufficient.
NOTE: If the tool will not be used for long periods of time, charge the battery
every 3-6 months.
NOTE: To prevent damage to the battery, when charge runs out, charge the
battery to reach full or no less than half charge before storage.
3.2 ON/OFF switch button (Fig. 3)
The cordless soldering iron is equipped with an ON/OFF switch button (5), an indicator (6)
and a heating indicator (4).
3.3 With ON/OFF switch button:
▪ Single click, power indicating.
Green: Enough power; Red: Low power.
▪ Press and hold 1s – power on.
Red: Operation after preheating 60s.
▪ Press and hold 1s – power off.
3.4 Release/set shipping mode
NOTE: this tool is preset to shipping mode (dormant state) which to avoid
the battery was discharged due to misoperation and the risk of fire, so the
switch cannot be start the tool.
Before first use, the soldering iron must be awakened by connecting the adapter to the power
supply, the charging indicator (6) shows red, the tool can be used normally after unplug the
adapter.
It is recommended that reset the tool to shipping mode when transport or storage. Press
and hold the switch button (5) 5-8s, release it after the red indicator (6) flashes 3 times and
make sure that the switch does not work.
