POWEG8050 EN
Copyright © 2022 VARO P a g e | 12 www.varo.com
▪ After use, always store the appliance safely and out of the reach of children.
▪ Do not cut against hard objects. This could cause injury or damage the trimmer.
▪ Do not use the trimmer to cut grass which is not in contact with the ground, for example,
do not cut grass which is on walls or rocks etc.
7 SAFETY WARNINGS GASOLINE
WARNING: Use extra care in handling fuels. They are flammable and the
vapours are explosive. The following points must be observed.
▪ Use only an approved container.
▪ Never remove the fuel cap or add fuel with the power source running. Allow engine
exhaust components to cool before refuelling.
▪ Do not smoke.
▪ Never refuel the machine indoors.
▪ Never store the machine or fuel containers inside, where is an open flame, such as a
water heater.
▪ If fuel is spilled, do not attempt to start the power source, but move the machine away
from the area of spillage before starting.
▪ Always replace and securely tighten the fuel cap after refuelling.
▪ If the tank is drained, this should be done outdoors.
8 BEFORE USE
WARNING! Never use a machine with faulty safety equipment. The machine’s
safety equipment must be checked and maintained as described in this
section. If your machine fails any of these checks contact your service agent
to get it repaired.
Always wear non-slip footwear and appropriate safety clothing such as
protective gloves, a hard hat, a protective mask and safety goggles as well
as hearing protection.
Check the area in which the appliance is to be used and remove any objects
that may be caught and slung away.
Before use and after dropping or other impacts, always visually inspect the
appliance to check whether the cutting tool, mounting bolts and the entire
cutting unit are damaged. Worn or damaged cutting tools and mounting bolts
must be replaced.
Always carry out a visual inspection before use to check whether the cutting
tools are worn or damaged. To prevent imbalance, worn or damaged cutting
tools and mounting bolts should be replaced only as complete sets.
8.1 Attaching the round handle (Fig. 2)
▪ Start by fitting the rubber ring (5a) on the shaft (10).
▪ Attach the barrier bar (6) onto the rubber ring (5a) from below.
▪ The pin (5b) of the barrier bar (6) must be pushed into one of the two holes of the shaft
(10) to lock into place.
▪ Push the round handle (5) onto the rubber ring (5a) provided on the shaft (8).
