550341
8
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
8
O2 Tech Reg
CARE AND MAINTENANCE
TRANSPORT and STORAGE
If possible, transport your Regulator Assembly (preferably dry) in a padded carry-
ing case or equipment bag separated from sharp items (i.e., dive knife, spear
gun, etc.) that might damage or scratch the components. You should also protect
the Second Stages from damage from heavy objects (i.e., dive light, first stage,
etc.).
Prior to storing your Regulator:
• Ensure that the complete Regulator is clean and dry.
• If you were unable to clean the Regulator prior to transport, or if it became
exposed to other equipment that was not thoroughly cleaned prior to trans-
port (such as a BC or Wet Suit), clean it thoroughly and allow it to dry natu-
rally as previously described.
POST DIVE CARE
As soon as possible at the end of each day of diving:
• Install the DIN Thread Protector Cap).
• If possible, immerse the entire Regulator Assembly in a warm fresh water
bath and soak for one hour, preferably while pressurized. DO NOT de-
press the Second Stage Purge Button while the Regulator is soaking. Doing
so will allow water to flow into the sealed portion of the First Stage.
• Remove from the bath and rinse all components of the Assembly with slow
running fresh water. DO NOT use full water pressure.
• Flush the ambient openings of the First Stage and the exterior of all compo-
nents thoroughly to remove dissolved salt and other contaminants.
• Flush the Second Stage by running water into the Mouthpiece and out the
Exhaust Ports. DO NOT depress the Purge Button while rinsing., doing so
will allow water to enter the First Stage.
• If possible, lay the complete Assembly flat in a cool, dry place (out of di-
rect sunlight) and allow the components to dry naturally.
• DO NOT inject or spray Lubricants into or onto the First and Second Stages.
Doing so can attract contamination that may subsequently interfere with
proper operation.
REPAIRS and SERVICE
WARNING: DO NOT attempt to disassemble or repair the
First or Second Stages, or to adjust the First Stage. Doing so
could cause malfunction while underwater resulting in
serious injury or death. It will also void the Regulator's
limited warranty.
Only the Oceanic factory can service an O2 tech Reg that is
used with breathing gases containing greater than 40% O2.
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Oceanic DIN USA Converter bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Oceanic DIN USA Converter in de taal/talen: Engels als bijlage per email.

De handleiding is 0,1 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info