619208
10
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
1XX-7801X
10
SK nv Niko sa Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: support@niko.be — www.niko.eu PM1XX-7801XR13375
Automatic and unwanted
switching
The motion detector switches on
after the mains voltage has been
interrupted.
The lighting is illuminated for
90 seconds before the
interruption. After that, the device
is in automatic mode.
Sunlight falls on the lens or in the
detection area.
Set the lux value to twilight.
Heat/cold penetrates through to
the detection area by way of an
open door or window.
Close the door or window or
move the device.
6. TECHNICAL DATA
dimensions
base: 31 mm (D)
motion detector: 30 mm (D)
power supply voltage 230 Vac ± 10%
mounting flush-mounting box with flush-mounting depth of min.
40 mm
connection terminals 5 (maximum capacity per connection terminal:
1 x 2.5 mm²)
no-load power consumption < 0.5 W
relay contact max. 10 A, 250 Vac, light- and motion-sensitive
maximum switching capacity 140 µF
maximum switching current 165 A/20 ms
detection angle
horizontal: 180° – vertical: 60°
(see illustrations below)
detection range 8 – 9 m
switch-off delay ± 1 – 30 min
light sensitivity ± 10 – 1000 lux
mounting height 0.8 – 1.2 m
ambient temperature -5 – +45°C
protection degree IP40
functionality may be used as master or as slave
8-9 m 8-9 m0
180°
50°
10°
0 m
0.8 - 1.2
m
7. WARNINGS REGARDING INSTALLATION
- The installation should be carried out by a registered installer and in compliance with the statutory regulations.
- This manual should be presented to the user. It should be included in the electrical installation file, and it
should be passed on to any new owners. Additional copies are available on the Niko website or via the Niko
support service. The latest manual for this product is available on the Niko website at any time.
- During installation, the following should be taken into account (non-exhaustive list):
- the statutory laws, standards and regulations.
- the technology currently available at the time of installation.
- this manual, which only states general regulations and should therefore be read within the scope of
each specific installation.
- the rules of proper workmanship.
This product complies with all of the relevant European guidelines and regulations. If applicable, you can find
the EC declaration of conformity regarding this product at www.niko.eu.
8. NIKO SUPPORT
In case of doubt or for the specific exchange procedure in case of a possible defect, contact the Niko support
service in Belgium at +32 3 778 90 80 or your wholesaler/installer. Contact details and more information can
be found at www.niko.eu under the “Help and advice” section.
9. GUARANTEE PROVISIONS
- The period of guarantee is four years from the date of delivery. The delivery date is the invoice date of purchase
of the product by the consumer. If there is no invoice, the date of production applies.
- The consumer is obliged to inform Niko in writing about the non-conformity, within two months after stating
the defect.
- In case of a non-conformity, the consumer only has the right to a product repair or replacement free of charge,
which shall be decided by Niko.
- Niko shall not be held liable for a defect or damage resulting from incorrect installation, improper or careless
use, incorrect operation, transformation of the product, maintenance that does not adhere to the maintenance
instructions or an external cause, such as damage due to moisture or overvoltage.
- The compulsory regulations of the national legislation concerning the sale of consumer goods and the
protection of the consumer in the countries where Niko sells, directly or via sister companies, subsidiaries,
chain stores, distributors, agents or permanent sales representatives, take priority over the above-mentioned
rules and regulations.
Pred inštaláciou a spustením systému si prečítajte celý návod. Návod uschovajte pre budúce použitie.
1. POPIS
180° detektor pohybu so zapustenou montážou je elektronický spínač detekcie pohybu, ktorý je určený
len na použitie v interiéri. Detektor pohybu zapne záťaž (osvetlenie), ak sa zistí pohyb zdroja tepla a ak je
intenzita denného svetla nižšia ako nastavená hodnota luxov. Zariadenie deteguje pohyb pomocou pasívneho
infračerveného snímača (PIR).
Zariadenie (aktivátor + snímač) je dodávané na predmontovanom kovovom prístrojovom spodku (45 x 45).
Rámček je potrebné objednať samostatne.
2. INŠTALÁCIA
2.1. Zapojenie
Nebezpečenstvo: Pred inštaláciou detektora pohybu odpojte všetky zdroje energie. Nepripájajte zariadenie k
napájaciemu zdroju až do dokončenia inštalácie (vrátane rámčeka).
A. Jeden svetelný okruh s jedným detekčným bodom
Pripojte detektor pohybu a záťaž podľa nasledujúcej schémy:
L
N
230 Vac
B. Jeden svetelný okruh s viacerými detekčnými bodmi
V tomto prípade musí byť priradený master a slave. K jednému detektoru master môžete priradiť najviac
osem detektorov slave.
Pripojte slave k master podľa schémy nižšie:
L
N
230 Vac
Slave Master
C. Použitie externého tlačidla alebo spínača
Ak sa má dať zariadenie ovládať aj ručne, k detektoru pohybu pripojte externé tlačidlo alebo spínač. Tlačidlo
alebo spínač môžete pripojiť buď k master alebo slave.
Pre pripojenie tlačidla alebo spínača postupujte podľa nižšie uvedenej schémy:
L
N
230 Vac
2.2. Montáž
Tip: Neinštalujte detektor pohybu na plochu s priamym slnečným svetlom ani v blízkosti zdrojov tepla alebo
vzdušných prúdov (ventilácia alebo klimatizácia). Môže to zbytočne aktivovať detektor pohybu.
Tip: Namontujte detektor pohybu (master) na miesto, kde sa dá intenzita svetla čo najlepšie merať (hodnota v luxoch).
Pripevnite detektor pohybu do montážnej krabice s hĺbkou zapustenia 40 mm vo výške od 0,8 do 1,2 m.
3. NASTAVENIA
Pod odklápacím krytom na prednej strane detektora pohybu sú dva potenciometre na nastavenie nasledovných
štyri parametrov:
svetelná citlivosť (± 10 – 1000 lux)
doba oneskorenia vypnutia (± 1 – 30 min.)
slave
testovací režim
1
2
3
4
1
2
3 4
10

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Niko-100-78010

Zoeken resetten

  • xxx-7801x , lichtkring met 2 detectiepunten, geplaatst door elektricien in nieuwbouwappartement, bewegingsmelder reageert zoals het hoort, maar
    1: bij voldoende daglicht: hoe uitschakelen? Nog niet gelukt dit in te stellen…
    2: verlichting al verschillende keren moeten vervangen, door teveel “aan en uit…?” Gesteld op 27-2-2022 om 08:50

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Niko 100-78010 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Niko 100-78010 in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 4,48 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info