INSTALLER’S SETTING OPTIONS
207
ENGLISH
206
INSTALLER’S SETTING OPTIONS
Static Pressure Step Setting(air conditioner)
This function is applied to only duct type. Setting this in other cases will cause malfunction.
This function is only available on some models.
This is the function that static pressure of the product is divided in 11 steps for setting.
● Press and hold ‘wireless remote controller signal receiver part’ of the remote controller for
3seconds or longer to enter the installer function.
● Select remote controller code value ‘32’.
- You can press ‘▲’, ‘▼’ button to change the code value.
● In value1, use ‘▲’, ‘▼’ button to select setting value, and press ‘Done’ button to complete set-
ting.
- If you do not press ‘Done’ button, the setting value will not be applied.
h Setting value
- 000 : use static pressure (code 06) set value.
- 001~011 : static pressure step (code 32) set value.
Guard timer(air conditioner)
It is a function that sets the minimum running time of outdoor unit cycle mode when switching
from cooling mode to heating mode and vice versa during Auto Operation mode.
Under the condition of cooling/heating switching, it switches between cooling and heating mode
after operation during the time scheduled in the Guard timer.
● Press and hold ‘wireless remote controller signal receiver part’ of the remote controller for
3seconds or longer to enter the installer function.
● Select remote controller code value ‘33’.
- You can press ‘▲’, ‘▼’ button to change the code value.
● In value1, use ‘▲’, ‘▼’ button to select setting value, and press ‘Done’ button to complete set-
ting.
- If you do not press ‘Done’ button, the setting value will not be applied.
NOTE
!
• Static Pressure (Code 06) setting will not be used if Static Pressure Step (Code 32) setting
is being used.
• For the static pressure value for each step, refer to the indoor unit in the product manual.
Value Guard time
0 0 minute
1 15 minutes
2 30 minute
3 45 minutes
4 60 minutes
