677867
30
Verklein
Vergroot
Pagina terug
1/140
Pagina verder
F4/F9 Amount: This controls the signal entity to be sent to the multi-effect and, in particular, to the pre-selected algorithm, that can
be modified using the VALUE +/- buttons which, if pressed together at the same time, will set the value to zero.
F5/F10 Delay and Chorus:
These control the signal entity to be sent to the delay or the chorus, when an appropriate algorithm has been select-
ed. Compared to all seen up to here, the parameters within the horizontal lines are only called up using the function
push button F5/F10, as there is no function push button available for the last line.
PAGE 3
From this page the musician can make some adjustments that are required to limit the keyboard range and the velocity for a Voice. It is thus
possible to avail of a number of timbres in different parts of the Right section (split) and to call up the timbre based on the key dynamics (veloc-
ity switch).
F1/F6 Voice: This indicates the timbre used for the Voice selected. To change it refer to all explained for page 1.
F2/F7 Range: For each Voice it is possible to indicate the lower and higher limit of the keyboard within which the timbre will be
played, simply by playing the relative note on the keyboard when selecting the value or by using the VALUE +/- push
buttons which, if pressed together at the same time, will reset the value, setting it in Off. When this parameter is in
Off the Voice will play on the whole part of keyboard to the right of the split point. To be able to play the Voice also
on the part of keyboard to the left of the split point, the adequate keyboard range is to be set.
F3/F8 Velocity Switch: This is used to enable the velocity switch mode, namely the use of the timbre according to the key dynamics, that can
be modified using the VALUE +/- push buttons. The operating modes may be:
Normal: The timbre is always enabled whatever the velocity value set.
Low: The Voice is enabled only for velocity values ranging from 0 to the velocity value specified in F10
Threshold with the VALUE +/- push buttons.
High: The Voice will only play for velocity values that range from the velocity value specified in F10 Threshold
to value 127 (maximum dynamics).
Cross: This can be enabled only for the first two Voices and it enables a gradual switching from one Voice to
the other according to the dynamics, where the central point of this switching is set by the F10 Threshold value.
F4/F9 Sustain - Portamento -Expression: this is used to enable, or otherwise, the use of the Sustain, the Portamento and the Expression.
The three lines of parameters can only be accessed using the function push buttons F4/F9.
F5 Modes: This is used to choose the polyphony response to the keyboard mode, to create interesting combinations between the
timbres.
Off: This means that no alternative polyphony response is enabled.
Duet: The first Voice Program will have priority as the highest note, the second Voice will have priority as the lowest note.
For example, if the first Voice is a clarinet and the second Voice a trumpet, when the two notes are played the clarinet
will always play the highest note whereas the trumpet will always play the lowest note.
Trio: As for Duet but with the third Voice that will always play the lowest note.
Steel: This is used to assign the pitch bend only to the lowest note between two notes played at the same time, realistically
simulating the typical Hawaiian guitar or pedal steel guitar effect.
Morph: Using the Modulation Wheel it is possible to control the mix between the two timbres assigned to Voice 1 and 2. When
the Modulation Wheel is set at minimum only the first Voice will be heard; when it is at maximum only the second Voice
will be heard. In this way it is possible to obtain a morphing between the two Voices in real time and controlled by the
musician.
SD1 Owner’s Manual
30
30

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Ketron-SD1

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ketron SD1 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ketron SD1 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,36 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Ketron SD1

Ketron SD1 Gebruiksaanwijzing - Deutsch - 156 pagina's

Ketron SD1 Gebruiksaanwijzing - Français - 140 pagina's

Ketron SD1 Aanvulling / aanpassing - Alle talen - 24 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info