606427
3
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
C
REPEATER OPERATION
Note:
Please consult your dealer for programming the repeater.
Due to the frequency stability on the 6.25 kHz bandwidth channel,
when operating the repeater using an optional OCXO unit, allow
the unit to warm up after turning the power on. Refer to the KXK-3
instruction manual concerning the warm up duration.
After turning on the power, wait for approximately 10 seconds for
the VCXO or 5 minutes for the OCXO (when mounting) to warm up.
During this time, the CH/STATUS Display will blink. The keys will
function when they are pressed.
When power is applied to the unit, the
POWER
indicator lights
green. Turn the
VOLUME
control clockwise until a click sounds,
to unmute the audio. Rotate to adjust the audio. Turn the
VOLUME
control counterclockwise fully to mute the audio.
The
BUSY
indicator lights green while receiving a signal and the
TX
indicator lights red while transmitting.
Rear Panel
q
RX
IN
jack
Connect an RX antenna or a duplexer to this BNC
receptacle.
w
TEST/SPKR jack
Test input/output jack. Connect an external speaker to
this jack.
e
CONTROL I/O jack
Connect a repeater controller or a remote panel to this
DB-25 interface.
r
SYNC 1 / 2 jack
Connect to another repeater to use synchronous frame
signaling for digital trunking.
t
LAN jack
Connect to Ethernet.
CONTROLS AND FUNCTIONS
Front Panel
q
wrt
yu
io
e
q
w
rt y
u
e
MICROPHONE
VOLUME
COM
OFF/
POWERCTRL OCXO BUSY TX
12
MON
TAKE
OVER
RPT
DISABLE
ABC
345678
STATUS
TEST/SPKR
RX TX
CONTROL I/O
SYNC
12
LAN REF OUT REF IN
FUSE
75
DC 13.8V
y
REF OUT jack
Connect to another repeater within the site to supply a
reference signal.
u
REF IN jack
Connect from another repeater within the site to receive a
reference signal.
i
FUSE
Insert 7.5 A blade fuse into this fuse holder.
o
DC
13.8V jack
Connect a 13.8 V DC power supply to this jack.
!0
TX
OUT
jack
Connect a TX antenna or a duplexer to this BNC receptacle.
i
o
!0
TRANSCEIVER OPERATION
Receive
Adjust the volume to your desired level. You may need to
readjust the volume if you are having interference while receiving
a message from your dispatcher or another member in your fleet.
The
BUSY
indicator lights green while a signal is being received.
Transmit
1
Listen to the channel before transmitting, to make sure it
is not being used.
2
Press the microphone
PTT
switch, then speak in your
normal speaking voice.
The
TX
indicator lights red while transmitting.
3
When you finish speaking, release the
PTT
switch.
!0
!
1
!
2
q
Speaker
w
CH/STATUS Display
Two 17-segment digits display the channel number, name,
or status.
e
STATUS
indicator
Indicates the status of the repeater. (NXDN mode)
r
Programmable Function keys
Press these keys to activate their programmable
functions.
t
COM jack
Connect to the PC using a RS-232C standard DB9
(Female) cross cable.
y
VOLUME
control
Turn clockwise until a click sounds, to unmute the audio.
Rotate to adjust the audio. Turn counterclockwise fully to
mute the audio.
u
MICROPHONE
jack
Connect a microphone to this 8-pin modular jack.
i
POWER
indicator
Lights green when power is supplied to the
DC 13.8V
jack. Blinks red when an abnormal voltage is present.
While blinking, the repeater cannot be used.
o
TX
indicator
Lights red while transmitting.
!0
BUSY
indicator
Lights green while a signal is being received.
!1
OCXO
indicator
The OCXO indicator shows the state of the reference
10 MHz oscillator :
Lights Green when using a reference signal from an
optional OCXO unit (KXK-3).
Lights Orange when using a reference signal from another
repeater.
Lights red when no reference signal is available or when
an error occurs.
Does not light when the reference signal is an internal
VCXO signal.
!2
CTRL
indicator
The CTRL indicator shows the control channel status
while using Digital trunking :
Lights Green when the repeater is used as control channel.
Blinks Green when using a non-dedicated control channel.
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kenwood NXR-900 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kenwood NXR-900 in de taal/talen: Engels, Frans, Spaans als bijlage per email.

De handleiding is 0,18 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info