28356
39
Verklein
Vergroot
Pagina terug
1/148
Pagina verder
Section 2 Installation
38
Operating the INSTALLATION menu
To access this menu:
Press
MENU
MENU
key to display the MAIN menu.
Select INSTALLATION> by
Joystick
up/down, push
Joystick
. The
INSTALLATION menu is displayed.
This menu includes various settings required for installation, such
as the selection of the external data input method and unit, or the
initial setting of the radar initial adjustment or the GPS/DGPS
antenna. After installing the RADAR1800, use this menu to make your
settings.
RADAR SET UP
The RADAR ADJUST menu contains settings which should be
done at installation or after any repairs to optimize the performance of
the radar system. It is recommended that the radar be run in transmit
mode for at least 10 minutes before adjusting the Preset Tuning in order
to stabilize the transmitter circuit first. It is also recommended to adjust
the Preset Tuning first as the other adjustments will be easier to do after
that. If Preset tuning is not correct, then the Auto Tune may not work
or may not work correctly and receiving targets will be decreased or
eliminated. If Preset STC is up too high the loss of closer in targets will
occur. These are the 2 most important adjustments for viewing target
echos. Bearing alignment and Range (Timing) adjustments are
important for correct picture orientation and safety.
In the INSTALLATION menu, select RADAR ADJUST> menu
by
Joystick
up/down, push
Joystick
.
The RADAR ADJUST menu is displayed.
TUNE PRESET
From the RADAR ADJUST menu move the
Joystick
up or down
to move the hiliter onto Tune Preset, then press the
Joystick
one time
to select it. The TUNE PRESET popup menu shows the tuning
condition. The bar graph in the bottom of the screen shows the relative
position of the adjustment control. Move the
Joystick
right or left
while watching the echo targets and the upper bar graph. The upper bar
graph should peak to the right at the same point where the targets show
as the largest. When you achieve the best adjustment, push the
Joystick
once to save it.
Perform this step after the radar has been transmitting for 10 minutes.
•Set the range scale to 3 NM.
•Turn SEA and RAIN all the way down.
•Turn IR off.
•Set gain to a level just below the level where noise specks show on the
screen.
•In the RADAR ADJUST menu, select TUNE PRESET by
Joystick
up/down, and push
Joystick
.
The TUNE PRESET pop-up menu is displayed.
•Move the bar by
Joystick
right/left to get the strongest signal back.
OFF
N 0° 00.000’
E 0° 00.000’
00/00/0000
00:00
12HOUR
SIMULATION
INITIAL POS.
CLOCK ADJUST
DATE & TIME
RADAR ADJUST>
DATA IN/OUT >
UNITS >
CALIBRATION >
OPERATION >
INSTALLATION
EBL BEARING
PRF SHIFT
BEARING
DISPLAY TIMING
TUNE PRESET
STC PRESET
RADAR ADJUST
REL
20
0
561
32
57
TUNE PRESET
40
39

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw JRC Radar1800 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van JRC Radar1800 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,05 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info