Helpline 00800 31133113
16
How can I run a code scan for one manufacturer only (code
0021)?
To run a code scan that is limited to the codes of one specific manufactu-
rer, proceed as described for "automatic code scan" (see above chapter).
However, in this case enter code 0021 followed by the code of your device
manufacturer. This code is listed in the appendix of this manual.
IMPORTANT!
As soon as the red LED flashes three times, the scan through the codes of
your manufacturer is completed. If your device has not yet responded, run
an automatic code scan.
Identifying the correct 4-digit code (after having run an
automatic code scan)
After using the automatic scan mode the remote will have selected a code
which is unknown to you. Its important to know which code has been
found so that it can be reinstalled should something happen to the remote.
Please follow the steps below.
Step 1 Select the device that you wish to control with your easytip by
turning the disk until the arrow points to the desired device.
(only for M2
TV/VCR
, M2
TV/SAT
, M2
TV/DVD
and M5)
Step 2 Press the key until the LED flashes twice (after approx. 2
seconds).
Step 3 Within 5 seconds enter code 0030. The red LED flashes twice,
indicating that the remote control is now in "code identify
mode".
Step 4 To identify the currently saved code, press the following keys:
for first digit
for second digit
for third digit
for fourth digit
These keys must be pressed in the above sequence. After each
digit key has been pressed, count the number of times the red
LED flashes. To repeat the reading procedure, press any of the
four keys again within 5 seconds. Repeat the reading until you
are sure that you have the correct code written down.
When reading the code, also include the initial flash of the LED
upon the pressing of keys into your count.
PLEASE NOTE!
If the LED does not flash after you have pressed one of the above selection
keys, the respective code digit is 0.
User Manual
