Helpline 00800 31133113
15
GB User ManualD BedienungsanleitungI Istruzioni per l’usoF Mode d’emploiNL Gebruiksaanwijzing
How to run an automatic code scan (code 0020)
Step 1 Switch on the respective device. For television sets, ensure that a
picture is displayed. If your TV set is in standby mode, switch it
on fully. For instructions, please refer to the TV set manual.
Step 2 Select the device that you wish to control with your easytip by
turning the rotary indicator until the arrow points to the desired
device. (only for M2
TV/VCR
, M2
TV/SAT
, M2
TV/DVD
and M5)
Step 3 Press the key until the LED flashes twice. (after approx. 2
seconds).
Step 4 Enter code 0020 (within 5 seconds). The LED again flashes twice
to indicate that the remote has entered its programming mode.
Step 5 Code scan for
TV set (for M1, M2
TV/VCR
, M2
TV/SAT
, M2
TV/DVD
and M5) or
SAT receiver (only for M2
TV/SAT
and M5)
After the LED has flashed twice, press the key and keep it
pressed until the device has switched off. During the code scan,
the LED flashes every 2 seconds, this indicates that the automatic
is in process. After the device has switched off, switch it on again
(using the remote) to check the other functions of the remote
control.
Code scan for VCR (only for M2
TV/VCR
and M5) or
DVD (only for M2
TV/DVD
and M5)
Insert a videotape or DVD and play it (by pressing the key
on your video recorder/DVD player).
During the code scan for your VCR/DVD player, press and hold
down the key until the videotape/DVD has stopped. Then
you can test the other functions of your remote control.
PLEASE REMEMBER THAT THE FIRST FOUND CODE MIGHT
NOT BE THE MOST SUITABLE FOR YOUR DEVICE.
Step 6 If all functions work as desired, press the key to save the
found code.
IMPORTANT!
After the device has been switched off (step 5), you have the option to test
the control functions. If a selected code does not support all required func-
tions, press the key to go to the next code. After all saved codes have
been scanned, the LED flashes three times.
User Manual
