683782
5
Verklein
Vergroot
Pagina terug
1/38
Pagina verder
The machine must not be operated in
areas endangered by risks of explosion.
The machine may be used only for
hard floorings in indoor areas and for
operation on plane areas with a maxi-
mum inclination of up to 2%.
Driving e.g. on ramps with a maximum
inclination of 10% is only allowed for
transportation. Uphill drive must not
exceed 1 minute and particular care
has to be taken.
Repair, maintenance and cleaning
work must only be performed if the
master key is removed.
Before working on the electrical system,
be sure to disconnect the battery
plug.
Taking other persons than the opera-
tor with the Hakomatic is not allowed.
If the Hakomatic is equipped with a
driver seat, it may only be turned on
when the operator is seated (seat
switch).
A perfect maintenance of the machine
mainly helps preventing accidents.
When performing repair, maintenance,
setting or other work the appropriate
tools have to be used. Other spare
parts than the genuine Hako spare
parts must at least equal the original
parts as far as the safety standards
are concerned.
The Hakomatic B 910 has to be chek-
ked by an expert in regular inter-
37
intervals for its proper and safe opera-
tion (we recommend a check once
yearly at least) and after modification
or repair.
The Hakomatic must be equipped
by brushes and pads as requires the
manufacturer (refer to section ”Tech-
nical data”). Using other brushes/pads
than indicated affects your safety.
Do not clean the machine by means
of vapor jet or high pressure cleaning
equipment.
For an increased danger of tilting, the
pneumatic tire equipment of the Hako-
matic is not admissible.
Do not allow water to enter any elec-
trical parts.
The machine is splash proof (IPX3).
Do not allow water to get in the ma-
chine in the driver’s seat area as it
may be collected on the battery stored
below the seat, remove water if
required.
Particular instructions for safe
handling of batteries
(See enclosed leaflet 88-60-2556)
Notes on warranty
The terms of the sales contact apply.
Damages are not subject to warranty
if they are due to non-compliance with
the maintenance and service provi-
sions. Any maintenance work has to
be performed by an authorized Hako
service work-shop and confirmed in
the „maintenance certificate“ which is
the warranty document.
The following is excluded from war-
ranty:
natural wear and tear after overload,
fuses and damages caused by inex-
pent handling and unauthorized modi-
fication of the machine.
Moreover, any claim for warranty be-
comes extinct if damages at the ma-
chine are caused by fitting of parts or
accessories without Hako’s prior and
explicit consent or by noncompliance
with the maintenance instructions.
The machine must not be operated in
areas endangered by risks of explosion.
The machine may be used only for
hard floorings in indoor areas and for
operation on plane areas with a maxi-
mum inclination of up to 2%.
Driving e.g. on ramps with a maximum
inclination of 10% is only allowed for
transportation. Uphill drive must not
exceed 1 minute and particular care
has to be taken.
Repair, maintenance and cleaning
work must only be performed if the
master key is removed.
Before working on the electrical system,
be sure to disconnect the battery
plug.
Taking other persons than the opera-
tor with the Hakomatic is not allowed.
If the Hakomatic is equipped with a
driver seat, it may only be turned on
when the operator is seated (seat
switch).
A perfect maintenance of the machine
mainly helps preventing accidents.
When performing repair, maintenance,
setting or other work the appropriate
tools have to be used. Other spare
parts than the genuine Hako spare
parts must at least equal the original
parts as far as the safety standards
are concerned.
The Hakomatic B 910 has to be chek-
ked by an expert in regular inter-
37
intervals for its proper and safe opera-
tion (we recommend a check once
yearly at least) and after modification
or repair.
The Hakomatic must be equipped
by brushes and pads as requires the
manufacturer (refer to section ”Tech-
nical data”). Using other brushes/pads
than indicated affects your safety.
Do not clean the machine by means
of vapor jet or high pressure cleaning
equipment.
For an increased danger of tilting, the
pneumatic tire equipment of the Hako-
matic is not admissible.
Do not allow water to enter any elec-
trical parts.
The machine is splash proof (IPX3).
Do not allow water to get in the ma-
chine in the driver’s seat area as it
may be collected on the battery stored
below the seat, remove water if
required.
Particular instructions for safe
handling of batteries
(See enclosed leaflet 88-60-2556)
Notes on warranty
The terms of the sales contact apply.
Damages are not subject to warranty
if they are due to non-compliance with
the maintenance and service provi-
sions. Any maintenance work has to
be performed by an authorized Hako
service work-shop and confirmed in
the „maintenance certificate“ which is
the warranty document.
The following is excluded from war-
ranty:
natural wear and tear after overload,
fuses and damages caused by inex-
pent handling and unauthorized modi-
fication of the machine.
Moreover, any claim for warranty be-
comes extinct if damages at the ma-
chine are caused by fitting of parts or
accessories without Hako’s prior and
explicit consent or by noncompliance
with the maintenance instructions.
The machine must not be operated in
areas endangered by risks of explosion.
The machine may be used only for
hard floorings in indoor areas and for
operation on plane areas with a maxi-
mum inclination of up to 2%.
Driving e.g. on ramps with a maximum
inclination of 10% is only allowed for
transportation. Uphill drive must not
exceed 1 minute and particular care
has to be taken.
Repair, maintenance and cleaning
work must only be performed if the
master key is removed.
Before working on the electrical system,
be sure to disconnect the battery
plug.
Taking other persons than the opera-
tor with the Hakomatic is not allowed.
If the Hakomatic is equipped with a
driver seat, it may only be turned on
when the operator is seated (seat
switch).
A perfect maintenance of the machine
mainly helps preventing accidents.
When performing repair, maintenance,
setting or other work the appropriate
tools have to be used. Other spare
parts than the genuine Hako spare
parts must at least equal the original
parts as far as the safety standards
are concerned.
The Hakomatic B 910 has to be chek-
ked by an expert in regular inter-
37
intervals for its proper and safe opera-
tion (we recommend a check once
yearly at least) and after modification
or repair.
The Hakomatic must be equipped
by brushes and pads as requires the
manufacturer (refer to section ”Tech-
nical data”). Using other brushes/pads
than indicated affects your safety.
Do not clean the machine by means
of vapor jet or high pressure cleaning
equipment.
For an increased danger of tilting, the
pneumatic tire equipment of the Hako-
matic is not admissible.
Do not allow water to enter any elec-
trical parts.
The machine is splash proof (IPX3).
Do not allow water to get in the ma-
chine in the driver’s seat area as it
may be collected on the battery stored
below the seat, remove water if
required.
Particular instructions for safe
handling of batteries
(See enclosed leaflet 88-60-2556)
Notes on warranty
The terms of the sales contact apply.
Damages are not subject to warranty
if they are due to non-compliance with
the maintenance and service provi-
sions. Any maintenance work has to
be performed by an authorized Hako
service work-shop and confirmed in
the „maintenance certificate“ which is
the warranty document.
The following is excluded from war-
ranty:
natural wear and tear after overload,
fuses and damages caused by inex-
pent handling and unauthorized modi-
fication of the machine.
Moreover, any claim for warranty be-
comes extinct if damages at the ma-
chine are caused by fitting of parts or
accessories without Hako’s prior and
explicit consent or by noncompliance
with the maintenance instructions.
The machine must not be operated in
areas endangered by risks of explosion.
The machine may be used only for
hard floorings in indoor areas and for
operation on plane areas with a maxi-
mum inclination of up to 2%.
Driving e.g. on ramps with a maximum
inclination of 10% is only allowed for
transportation. Uphill drive must not
exceed 1 minute and particular care
has to be taken.
Repair, maintenance and cleaning
work must only be performed if the
master key is removed.
Before working on the electrical system,
be sure to disconnect the battery
plug.
Taking other persons than the opera-
tor with the Hakomatic is not allowed.
If the Hakomatic is equipped with a
driver seat, it may only be turned on
when the operator is seated (seat
switch).
A perfect maintenance of the machine
mainly helps preventing accidents.
When performing repair, maintenance,
setting or other work the appropriate
tools have to be used. Other spare
parts than the genuine Hako spare
parts must at least equal the original
parts as far as the safety standards
are concerned.
The Hakomatic B 910 has to be chek-
ked by an expert in regular inter-
37
intervals for its proper and safe opera-
tion (we recommend a check once
yearly at least) and after modification
or repair.
The Hakomatic must be equipped
by brushes and pads as requires the
manufacturer (refer to section ”Tech-
nical data”). Using other brushes/pads
than indicated affects your safety.
Do not clean the machine by means
of vapor jet or high pressure cleaning
equipment.
For an increased danger of tilting, the
pneumatic tire equipment of the Hako-
matic is not admissible.
Do not allow water to enter any elec-
trical parts.
The machine is splash proof (IPX3).
Do not allow water to get in the ma-
chine in the driver’s seat area as it
may be collected on the battery stored
below the seat, remove water if
required.
Particular instructions for safe
handling of batteries
(See enclosed leaflet 88-60-2556)
Notes on warranty
The terms of the sales contact apply.
Damages are not subject to warranty
if they are due to non-compliance with
the maintenance and service provi-
sions. Any maintenance work has to
be performed by an authorized Hako
service work-shop and confirmed in
the „maintenance certificate“ which is
the warranty document.
The following is excluded from war-
ranty:
natural wear and tear after overload,
fuses and damages caused by inex-
pent handling and unauthorized modi-
fication of the machine.
Moreover, any claim for warranty be-
comes extinct if damages at the ma-
chine are caused by fitting of parts or
accessories without Hako’s prior and
explicit consent or by noncompliance
with the maintenance instructions.
Scrubmaster is not allowed.
Scrubmaster is equipped with a
Scrubmaster B140 R has to be chek-
Scrubmaster must be equipped
Scrub-
master B140 R is not admissible.
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hako Scrubmaster B140R bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hako Scrubmaster B140R in de taal/talen: Engels als bijlage per email.

De handleiding is 1,09 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info