622199
19
Verklein
Vergroot
Pagina terug
1/64
Pagina verder
Troubleshooting
At all failures it is first necessary to check whether the
appliance is sufficiently and permanently supplied
with pneumatic oil.
Failure Cause Removal
Compressed air
leaking from the
cover hole
O-rings are
damaged or
dirty, which has
been caused by
a foreign item.
Clean or
replace the O-
rings.
Compressed air
leaking from the
valve
O-rings are
damaged or the
valve is faulty.
Replace the O-
rings and valve.
Compressed air
leaking between
the body and
cylinder cover
Screws are
loosened. O-
rings are
damaged.
Tighten the
screws.
Replace the O-
rings.
Piston not fully
returning, idle
strokes
Appliance
placed too
weakly or too
shortly.
Piston dragging
as it is not
lubricated.
O-ring is faulty.
Place the
appliance
stronger.
Lubricate the
cylinder surface
contact.
Replace the O-
ring, check the
operating
pressure.
Nails not fully
fired
Air pressure too
low.
Hose piping with
a too small
cross section.
Appliance not
lubricated.
Firing
mechanism
worn out.
Gradually
increase the
pressure by 0.5
bar to make
sure nails are
fired properly.
Hose piping
inner diameter
at least 6 mm.
Clean and
lubricate the
parts.
Grind the firing
mechanism
down by app.
0.2 mm.
Failure Cause Removal
Nails breaking
and overlapping
Firing
mechanism
significantly
worn out.
Appliance
placed too
weakly.
Replace the
firing
mechanism.
Place the
appliance
stronger.
Appliance
running too
slowly
O-ring is
damaged.
Valve is
damaged.
Replace the O-
ring.
Replace the
valve
completely.
Firing
mechanism is
blocked by nails
Wrong nails
used.
Firing
mechanism has
fray.
Insert correctly
appropriate
nails.
Remove the
firing
mechanism off
fray.
Appliance not
working
Check the air
inlet. Operating
pressure may
be too low.
Increase the
operating
pressure.
However, max.
operating
pressure must
be adhered to.
Irregular
appliance
operation
Install a set of pins with a head
valve.
Air leaking from
the appliance in
the bottom part
Tighten the screws or install the
absorber or a set of pins.
Wrong reverse
movement
Clean the appliance and install an
absorber or a set of pins.
Other failures
Contact an expert, seller or
distributor.
Clamps/nails
blocked in the
guide plate
Magazine dirty
Belt with
clamps/nails
not moving fully
forward
Ram worn-out
Clean (blow) the
magazine.
Wrong
clamps/nails
have been used.
Use appropriate
clamps/nails
Maintenance table
Following the maintenance instructions specified in
this document will provide this high-quality product
with long and trouble-free operation. Disconnect the
appliance from the compressed air source for
maintenance and treatment. To ensure long and
trouble-free working of your tacker/nailer, it is
necessary to clean it every day and regularly lubricate
it. For this purpose, special tool oil should only be
used:
Via oil mist
lubricator
A complete maintenance unit includes
an oil mist lubricator and is fitted on
the compressor.
Via lubricator on
the piping
In the immediate vicinity of the
appliance (app. 50 cm distance), a
lubricator sufficiently providing the
appliance with oil is installed on the
lubricator piping.
Manually If your appliance has no maintenance
unit or lubricator on piping, 3-5 oil
drops must be added to the
compressed air connection before the
pneumatic appliance is put into
operation. If the pneumatic appliance
has been out of service for several
days, 5-10 oil drops must be added to
the compressed air connection before
switching the appliance on. Store your
pneumatic appliances only in dry
rooms.
Lubricate the appliance with special oil for pneumatic
appliances using an extension if there has been a long
operation break.
Store the appliance in a cleaned, dry, dust-free condition
and at temperatures above 5° C.
19
19

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gude 40205 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gude 40205 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans als bijlage per email.

De handleiding is 3,27 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info