330674
8
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
Instructions for use, installation and connection
10
Oven ceiling
(differ according to different models)
To facilitate the cleaning of the ceiling some ovens are
equipped with the foldable infrared heater.
Before lowering the infrared heater disconnect the appliance
from the mains by unlocking the fuse or switching off the
main switch.
The heater must be cooled down, otherwise you might get
burned!
Never use the heater in the lowered position!
Before cleaning remove all pans, grids and guides, and using
suitable tools (knife or a screwdriver) loosen the cross bar from
its side supports (see fig.). Use your other hand to hold the
heater and fold it downwards.
After cleaning simply push the heater back and the cross bar
will click into position.
Removing oven door
(differ according to different models)
Open the door to the horizontal position. Pull the bottom hinge
supports upwards to the vertical position and lock them to the
latch of upper hinge support. Close the door halfway (see fig.)
and pull it out.
For reinserting the door repeat the procedure backwards. Insert
the door in half open position (at an angle of 60°) by pushing
them all the way in during opening. Be sure that the notches on
bottom hinge carriers fit exactly the oven floor. Now open the
door completely, remove the hinge clamps from the upper
hinge latches and return them into the horizontal position.
1 door hinge in 2 door hinge during
operating position dismantling
Removing oven door with a single axe hinge
(differ according to different models)
Open the door completely and turn the removable locks
backwards (see fig). Then close the door slowly and let the
locks fit to the notches. At an angle of about 15° lift the door
slightly up and pull the door from the hinge supports (fig. 2).
For reinserting the door repeat the procedure backwards. Insert
the door at an angle of about 15° into the hinge supports by
pushing them forward and downwards, so the hinges lock into
their slots (fig. 3). Check if the hinges are locked into their
respective slots.
Now open the door completely and turn the removable locks
into their original position. Close the door slowly and check if
they close properly (fig. 4). If you have trouble closing the door,
check if the hinges are properly inserted into their slots.
Attention! Never let the hinge locks spring out, as the springs
are strong and may cause injuries.
Accessories
Accessories, like biscuit tray, oven grid, etc. are cleaned with
hot water and the usual detergent.
Special enamel
Oven, interior door lining, baking tray and grease interception
pan are coated with special enamel, with smooth and resistant
surface.
This special coating facilitates cleaning at room temperature.
Troubleshooting guide
Any unskilled attempt to repair the appliance is extremely
dangerous as it might cause electric shock and short circuit. To
avoid such injuries any repairs may be performed only by
qualified personnel, or after sales service.
However, there are some minor faults which may be easily
removed by the user, in accordance with the instructions that
follow.
Important!
If the malfunction of the appliance was caused by the improper
use, the service visit during the warranty period is not free of
charge.
Following are some simple advice how to repair minor faults:
Program clock indicates faulty values or switches on and
off intermitently…
Switch the cooker off, disconnect it from the mains for a few
minutes (unlock the fuse or switch off the main switch), then
reconnect it to the mains and set the correct daily time.
Program clock display is flashing…
There was a power failure, or the cooker had been connected
to the mains for the first time. All settings are erased. Set the
correct time of day to be able to activate the oven. After
operating in automatic mode, the oven switches off, the display
indicates time, and the beep is heard. Take the food from the
oven, set the temperature selection knob and the mode knob
into their original positions. Select the "Manual mode", and use
the oven in a conventional mode (without programming).
Signal lamp does not turn on....
are all the required switches properly activated?
is the mains power fuse burned?
is the temperature regulator properly set?
Fuses often burn out...
Call the serviceman or your electrician!
Oven illumination is not on....
Exchange of oven bulb is described in the section
"Replacement of parts".
Oven does not heat up...
is the mains power fuse burned?
is the temperature regulator set correctly?
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gorenje b 2410 e bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gorenje b 2410 e in de taal/talen: Engels als bijlage per email.

De handleiding is 0,62 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info