22
Electrical connection
Connect the appliance only to 230 V and 50 Hz
alternating current via a correctly installed socket
with protective conductor. See rating plate
for required fusing 9*.
The socket must be near the appliance and freely
accessible following installation.
The connection may be modified by technicians
only.
A power cord extension may be purchased from
customer service only.
Use only a residual current operated circuit-
breaker which features the symbol ‚. Only this
extension guarantees compliance with
the currently valid regulations.
Removing the appliance
Also observe the sequence of worksteps here.
1 Disconnect the appliance from the power supply.
2 Turn off the water supply.
3 Disconnect the waste water and fresh water
connections.
4 Loosen the fastening screws under the worktop.
5 If fitted, remove the base panel.
6 Pull out the appliance, carefully pulling the hose
behind.
Transportation
Empty the dishwasher and secure loose parts.
Drain the appliance according to the following
steps:
1 Turn on the tap.
2 Open the door.
3 Switch on the main switch (.
4 Select programme +.
The expected programme duration is indicated
on the numerical display @.
5 Close the door.
Programme sequence starts.
6 Open door after approx. 4 minutes.
7 End the programme by simultaneously pressing
buttons # and 3.
8 Close the door.
9 Open door after approx. 1 minute.
The numerical display indicates ‹.
10 Switch off main switch ( and turn off the tap.
Transport appliance upright only.
(This prevents residual water from running
into the machine control and damaging
the programme sequence.)
Protection against frost
If the appliance is in a room where there is a risk of
frost (e.g. holiday home), empty the appliance
completely (see Transportation).
Turn off the tap, disconnect supply hose and
drain water.
