Regularly clean the filter in the water inlet. To do this, unscrew the water inlet connector, remove the
filter with a screwdriver or similar tool and check that it is undamaged. Fasten everything firmly and
correctly in the appropriate place. Never use the cleaner without a filter!
Keep the ventilation openings of the machine clean in order to prevent obstruction of the cooling
function.
Regularly grease the O-rings of the connectors in order to prevent them from drying out.
Repairs and inspections must only be carried out by your supplier or appropriately trained and
authorised persons. Inexpertly executed repairs will nullify the guarantee.
Never carry out repairs!
RECYCLING
Your high-pressure cleaner is not normal household waste. When you finish using it, take it to a waste
collection point designated by your local council.
PROBLEMS AND SOLUTIONS
The machine does not start
- Is the plug inserted into the socket?
- Is the socket not in good working order? Try another.
- Is the fuse burnt out? Replace it.
- Extension cable broken. Use another cable.
The pressure fluctuates
- The pump is sucking air in. Seal the connections correctly.
- Valves are dirty, worn or broken. Have them replaced.
- Pump seal work. Have it replaced.
- The nozzle is partially blocked. Clean it.
The machine stops
- Fuse burnt out. Replace it and switch other equipment off.
- Check that the socket has the correct Voltage.
- The thermal safety feature is activated. Allow it to cool and remove the cause of the overheating.
- The nozzle is partially blocked. Clean it.
The fuse burns out
- The electrical installation is too light. Connect the machine to an installation that has greater Amperage
than the machine. Do not use an extension cable.
The machine vibrates
- Air in the water supply hose. Allow it to escape by running water through the machine while it is
switched off.
- Problems with the water supply. Does it meet the requirements? Do not use an excessively long or thin
hose (min. ½”).
- The nozzle is partially blocked. Clean it.
- Water inlet filter is dirty. Clean it
- There is a kink in the hose. Straighten it.
The machine regularly starts and stops by itself
- Pump or spray lance are leaking. Have them repaired or replaced.
The machine starts but does not supply water
- Pump, hose or accessories are frozen. Allow them to thaw and then check them.
- No water supply. Ensure that there is a water supply.
- Filter blocked. Clean the filter.
- Nozzle blocked. Clean the nozzle.
Please contact your dealer if there are any other problems!
