163877
7
Verklein
Vergroot
Pagina terug
1/26
Pagina verder
Crossovers / filters (general)
DLS A-series amplifiers include highpass filter
(HP) and lowpass filters (LP).
The HP-filters can be used in one of two ways.
Either as a subsonic filter together with a
subwoofer to remove the lowest frequencies which
often causes a rumbling bass reproduction. A nor-
mal setting is 20 - 30 Hz.
The HP-filter can also be used together with a front
or rear stereo system to remove frequencies below
the crossover setting. In a system with a separate
subwoofer it´s normal to limit the bass reproduction
to the front system. A normal setting is between 80
- 100 Hz, but feel free to try other settings.
If you have problems with the mid bass driver
”reaching the bottom” (the voice coil reches the bot-
tom pole plate) at high volumes, use the HP-filter
to avoid this with a setting at 50 - 80 Hz.
A subsonic filter is actually a HP-filter.
The LP-filters are normally used when you connect
a subwoofer in bridge mode. The filter can be
switched in and out. A normal setting is 60 - 80 Hz.
The filter slope is 12 dB.
Active crossover.
A4 and A7 the LP and HP-filters have a frequency
range making it possible to use them for active
crossover to a 2-way speakersystem.
DLS A2 och A3
DLS A2 and A3 has an adjustable LP-filter that can be
switched in/out. It can be set from 50 - 125 Hz. There
is also an adjustable HP-filter that can be switched
in/out.The filter is adjustable from 20 - 200 Hz.
PHASE SHIFT BUTTON ON A3:
DLS A3 has a button marked ”PHASE”. Use this
button to phase reverse the speaker output. The
button is only working when the lowpass filter is in
use. Only use this button when you want to phase
reverse a subwoofer to get the best sound.
DLS A4
DLS A4 is equipped with adjustable HP-and LP- filt-
ers on all channels. These can also be switched in/
out. The filters are equipped with a multiplication
button for improved flexibility.
The filter setup are as follows:
Front:
Lowpass (LP) 50 - 125 Hz
Highpass (HP) 20 - 200 Hz alt 60 - 600 Hz (x 3 button)
Rear:
Lowpass (LP) 45 - 200 Hz alt. 90 - 400 Hz (x 2 button)
Highpass (HP) 20 - 200 Hz
The x2 and x3 buttons are used if you run a 2-way
system with active crossover between mid-bass and
tweeter.
DLS A5
Front channels:
DLS A5 has an internal adjustable HP-filter that can
be switched in/out. It can be set from 50 up to 150
Hz.
Sub / mono channel:
The mono channel filters are for use only with one or
more subwoofers There is a LP-filter adjustable from
40 up to 90 Hz, and a subsonic filter at 25 Hz that
can be switched in-out.
DLS A6
DLS A6 is a mono amplifier for use only as a
subwoofer amplifier.
It has a fixed 25 Hz subsonic filter that can be switched
in/out.
It also has a LP-filter adjustable from 50 - 125 Hz.
This filter can not be disconnected.
DLS A7
This is a five channel amplifier with a lot of filter
possibilities described in detail on page 8.
Crossovers on each model
ULTIMATE A-series
7
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw DLS a7 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van DLS a7 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,45 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info