Marking plate was located on bottom enclosure
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The lighting flash with arrowhead symbol, within an equilateral triangle, is
intended to alert user to the presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of sufficient magnitude to constitute
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert user
to the presence of important operating and maintenance (servicing) instruction
in the literature accompanying the appliance.
CAUTION
For Compact Disc Units Only:
INVISBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED
OR DEFEATED. AVOID DIRECT EXPORSURE TO LASER BEAM.
11
Connecting Optional Equipment
Specification
Frequency Range : AM 530 - 1700 KHz
: FM 88 - 108 MHz
Power Supply : AC 120V ~ 60Hz
Power Consumption : 18W
Antennas : External antenna for FM
: Built-in ferrite bar for AM
Speaker : 4 8 ohm 5W x 2
Replacement Needle : NP4
*
DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
WARNING:
To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
CAUTION:
Use of controls or adjustments or performance of procedures other than those specified
may result in hazardous radiation exposure.
There is no Power
1 The AC plugged is not well connected.
2 Make sure the Power Button is pushed in.
There is no Sound
1 Check the volume level by turning the volume
knob.
2 Make sure the LINE IN SWITCH is in the OFF
position if the LINE IN JACK is not being used.
Turntable will not work
1 Make sure the function switch is set to phono.
2 Make sure the protective needle cover is
removed.
CD does not play
1 Check to make sure CD is inserted correctly
(label side facing up).
2 Check that the surface of the CD is clean
3 Make sure function switch is set to CD.
Troubleshooting
Auxiliary Input
1 You can connect external components to your
unit by using the Auxiliary Input.
2 Plug Auxiliary cable into the LINE IN Jack (26)
on the back of your unit.
3 Switch the LINE IN Switch (27) to the ON
position.
4 Plug the other end of the Auxililary cable into
the output jack on your desired external
component.
5 Check the volume level of your external
component.
6 See operators manual for correct operation of
the external component.
NOTE: When not using the Auxiliary Input, make
sure the LINE IN Switch (27) is in the
OFF position.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
