607733
34
Verklein
Vergroot
Pagina terug
1/34
Pagina verder
3534
123564
Operation instructions
Switch-on:
Establishing aBluetooth connection (pairing):
Disconnect aBluetooth connection:
If it is not possible to establish aconnection, please check and update the software release
(firmware) of your mobile phone or of the hands-free set. Youwill find an overview dealing with
this subject in the internet under www.bury.com. In addition it is possible that you must delete all
devices connected to your mobile phone first in order to enable acorrect identification of the
hands-free set and aconnection can be established. If you have questions with regard to the
menu navigation, functions and operation of your mobile phone, please refer to the operating
guidelines of your mobile phone. Depending on the manufacturer and type, this can differ
considerably between phones.
The hands-free set has amemory for the storage of the identification of up to 5mobile phones.
In case asixth mobile phone is connected, the oldest entry in the hands-free set memory is
cancelled.
If you wish to cancel aBluetooth connection, you can either disconnect it conveniently at the
hands-free set or at your mobile phone. In addition, the connection is disconnected, if you move
too far away from the vehicle while taking your mobile phone with you and thus leave the
reception radius of the hands-free set.
After 15 minutes without an active Bluetooth connection (stand-by), the hands-free set is
switched-offautomatically if it is still supplied with power.This serves to protect the main
battery.Ifyou come back to your vehicle within that period of time you can initiate amanual
interconnection by pressing key 5for three seconds.
Insert the cigarette lighter plug of the hands-free car kit (HFCK) into the cigarette lighter jack (12
Volt) of your vehicle, if you have not realized the power supply of the HFCK otherwise. Now
establish the power supply of the HFCK (e.g. by 'ignition on'). Please press key 5for 3seconds
to activate the system. The HFCK then tries for tries for about 10 seconds to establish a
connection with the mobile phone connected last.
If you wish to establish aBluetooth connection for the first time, you have to activate the
Bluetooth function of your mobile phone and search for Bluetooth devices. In this case, search
for adevice labelled "Comfort VISION“. If several devices were identified, please select the
HFCK and enter the PIN number 1234. The Bluetooth connection (pairing) will then be
established between your mobile phone and the HFCK. The HFCK supportsthe profiles
"hands-free operation" and "OPP". Please set your mobile phone accordingly or check if these
profiles are supported.
1=leftarrow key
2=call answering key
3=volume control key -turn down
4=volume control key -turn up
5=call termination key
6=right arrow key
Please note that the capacity of your mobile phone's storage battery can quickly decrease
when the Bluetooth function is active. If you do not want to use the Bluetooth function anymore,
e.g. if you leave the vehicle for alonger period, it is recommended to deactivate this function.
Please note that some of the functions/displays specified subsequently are only possible if they
are supported by the mobile phone!
After switching on the hands-free set the main mask appears. It informs you whether amobile
phone is connected via Bluetooth or not. If yes, itsBTidentification name appears on the
display.Additionally,the field strength (the reception) is displayed as well as the storage
capacity of the mobile phone and the name of the network operator.
With the leftarrow key (key 1) and subsequently with the right arrow key (key 6) you access the
submenu structure. This consistsofthe sub-menus:
-Call lists(Dialled calls, Received calls, Missed calls),
-Phonebook,
-Bluetooth (Disconnect, SW-Update, SW-Version),
-Language,
-Pair remote control (CV 9011).
In order to call up asubmenu or afunction, please press key 2. In the first line of the display,the
respective menu category is displayed and in the middle line the current menu item is
displayed. In order to return to the superordinate menu, please press key 5. For the further
keyboard layout in the respective modi please refer to the following descriptions.
The structure of the submenu 'Call lists' is similar to the menu navigation, as you are used to it
from mobile phones. It can thus trace the numbers dialed, the calls that you have received and
the calls that you have missed.
In the submenu 'Phonebook', the first 100 memory entries of the SIM card (phonebook)
inserted in the mobile phone are displayed. The display of the hands-free set liststhe entries in
alphabetical order,itcould however contain the storage memory numbers 16, 3, 78, 45 etc. If
you have more than 100 entries (names +phone numbers) stored on your SIM card and you
want the most important of them to be displayed, you should perform arelocation. Please refer
to the operation manual of your mobile phone for details. Please note that the entries stored on
your mobile phone (addressbook) are not displayed.
Menu navigations:
Exceptions are mobile phones
transmitting datatothe HFCK via the "Object Push Profile" (OPP). The datatransmitted via this
protocol are permanently saved by the HFCK. The memory can only be deleted after the
function "software update" has been performed. It is sufficient here to call the function without
uploading an update. If the main mask appears after the "Please wait" message, please
disconnect the power supply (e.g. by removing the monitor). After re-commissioning the
memory is deleted.
In the next sub-menu 'Bluetooth' the sub item 'Disconnect' enables you to disconnect an active
Bluetooth connection from the HFCK. The HFCK then switches to the stand-by mode. In the
sub item 'SW-Update' you can replace the version of the system software (firmware) which is
transferred to the hands-free car kit by an updated version. For identifying the current firmware
of the HFCK and how to replace it, please refer to the corresponding product category on our
homepage under www.bury.com. There, the corresponding files will then be at your disposal for
download as soon as anew firmware is available.
34

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bury Comfort Vision 9010 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bury Comfort Vision 9010 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools als bijlage per email.

De handleiding is 1 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info