582033
5
Verklein
Vergroot
Pagina terug
1/14
Pagina verder
5
Unpacking the System
Carefully unpack the speakers. If there is any sign of damage from transit, report it immediately to your dealer or delivery service.
Retain the shipping carton and packing materials for future use.
Grilles
The cloth grilles should remain on the speaker during normal use. However, to remove a grille, use your fingers to carefully
pry the top edge of the grille away from the cabinet so you can insert your fingers between the grille and the cabinet. Then
slide your fingers down the inside of the grille frame from top to bottom which will cause the grille to pop free. The grille is
NOT designed to be removed by only pulling on one side. The pins that hold the grille can be damaged. Also, do not use any
objects other than your fingers to remove the grille as the finish or grille may be damaged. Be careful to keep rings, watches
and other sharp objects from scratching the finish or tearing the grille cloth.
To replace the grille, carefully align the two pins at the top of the grille with their corresponding grommets and gently push
them in until the grille is supported by the grommets. Then work your way down the grille gently pushing the grille pins into
the grommets evenly until the grille is fully seated. Be careful to align the pins with the grommets so the cabinet, grille pins
and grommets are not damaged. Also, take care to support the speaker so it does not tip over or fall off its mounting location
while the grille is being removed or replaced. MCenter Note: The same grille removal and replacement procedures apply
to the MCenter except you will begin at the left or right side and work towards the opposite side. MSubwoofer Note: The
MSubwoofer grille is not removable.
Feet & Spikes
The M350, M340 and M250 come with rubber feet installed at the factory which are ideal for hardwood floors. Spikes are also
included for placement on a carpeted surface. To install the spikes, carefully lay the speaker on its back on a soft, debris-free
surface and remove the rubber feet by hand turning them counter-clockwise. Thread the spikes by hand to make sure they
are inserted properly. Save the rubber feet for future use.
The M25, MCenter, and MSurround come with rubber stand-offs that are designed to be attached to the bottom of the
loudspeaker
when stand, shelf or cabinet mounting. This will minimize the vibration transferred from the loudspeaker to the
stand, shelf or cabinet. It will also help to protect the finish of the loudspeaker and the mounting location. The MSubwoofer
comes with rubber feet installed at the factory.
MSurround Note: It is recommended to mount the rubber stand-offs on the back of the side panels of the MSurround if it is
going to be wall mounted. This will minimize the amount of vibration that is transferred directly to the wall. You may need to
adjust the depth of the mounting screws to help ensure that the speaker is not mounted too loosely or too tightly.
Where to Place the Speakers
Downloaded from www.Manualslib.com manuals search engine
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Boston Boston M 250 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Boston Boston M 250 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,51 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Boston Boston M 250

Boston Boston M 250 Gebruiksaanwijzing - Deutsch, English, Français, Italiano, Espanõl, Svenska - 72 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info