693646
27
Verklein
Vergroot
Pagina terug
1/30
Pagina verder
Overall wear of the
screw shaft.
Replace the screw shaft.*
transported into the
combustion chamber.
The turnstile chain was
damaged.
Replace the turnstile chain.*
Boiler fan cable is
disconnected (or
damaged).
Connect (or replace) the boiler fan cable.* Boiler fan does not
work.
The fan is damaged. Replace the boiler fan.*
The fan was clogged by
dust.
Clean the boiler fan.* The fan is noisy in
operation.
The fan bearings are
worn.
Replace the entire boiler fan.*
The fan does not rotate
during boiler
modulation at the
lowest output values.
The set values of the fan
speed are too low.
Increase the fan speed on the boiler
controller so as to guarantee its smooth
operation.
Water from the
emergency fire-fighting
equipment leaked into
the fuel feeder.
The fuel burnt through
to the fuel feeder, which
activated the
thermostatic valve.
Remove wet fuel from the feeder, fill the
container with new dry fuel and start-up the
boiler.
Water from the
emergency fire-fighting
equipment leaks into
the fuel feeder.
The thermostatic valve
on the feeder leaks.
Replace the thermostatic valve.
The boiler is filled with
wet fuel.
Refill the container with dry fuel. The walls of the fuel
tank are covered with
droplets of water.
The temperature in the
boiler room is low
(about 12 °C or less)
The boiler room requires a higher air
temperature (boiler room wall insulation,
installation of heating radiator to the boiler
room, etc.).
A short time passed
after firing in the boiler.
Let the boiler thoroughly flame up.
Fuel dosing is set to a
lower output.
Adjust the fuel dosing according to the
control unit instruction manual.
The boiler cannot reach
the rated output during
operation.
The boiler uses non-
prescribed fuel (high
humidity, lower calorific
capacity, etc.)
Refill the container with prescribed fuel.
The boiler is clogged
with soot.
Clean the heat transfer surfaces of the boiler
body.
The boiler is
overheating.
Reduce fuel dosage.
High chimney draft. Install a chimney flue draw limiter (this
activity must be performed by a specialized
company).
Ceramic reflector is not
installed in the boiler
body.
Install a ceramic reflector according to the
instruction manual.
The flue gas
temperature is higher
than specified in the
instructions.
The firing flap in the
boiler body is open.
Close the firing flap using the cleaner lever
and firing flap and secure it with a locking
screw with a plastic head.
Low chimney draft. Have a chimneysweeper check the value of
the chimney draft. If the measured value is
less than the value required (see
instructions), it is necessary to make
adjustments to the chimney.
Smoke appears in the
boiler room or fuel
container.
The boiler door and / or
the top cover of the
boiler body and / or the
fuel tank cover is not
closed properly.
Duly close the boiler door and / or the top
cover of the boiler body and / or the fuel tank
cover properly.
27

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Benekov S100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Benekov S100 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,02 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info