42
zone:8.00;
GPS:NO(0);
GPRS:OK(73);
pw:123456;
Check the data received in the SMS with the device number.
- If the ID / IMEI / REG CODE number is different from the badge
on the watch, set a new IMEI number.
Send from the phone to the number of the card installed in the
device SMS with the following text:
pw,123456,imei,xxxxxxxxxxxxxxx#
- device after receiving the SMS with the code, it sends back in the
SMS reply with the correct IMEI number, for example:
pw,123456,imei,359614514986574#
Check in the application, on the device list, whether the registered
ID number matches the watch's ID.
- If IP_URL and PORT are different than in the example above, send
an SMS from the phone to the device number with following text:
pw,123456,ip,52.28.132.157,8001#
- the device in response sends a text message about the content
[surl,52.28132.157,port,8001#]Ok.!
After that it will work properly.
-The GPRS / NET line from the example above should contain the
word OK and the signal strength in parentheses. If the information
contains the word NO, it means that the device is not connected to
the internet. In that case, go back to the beginning of this
paragraph and follow the guidelines.
Could not call watch. The signal is busy or subscriber does not
answer
Reason: The device does not recognize the incoming number or in
application is set to do not disturb mode.
- Check if the number you are calling from is unlisted.
- Check if contact numbers are set in the application.
