309227
12
Verklein
Vergroot
Pagina terug
1/14
Pagina verder
70
RECOVERING AN OBJECT THAT FALLS
BETWEEN THE DRUM AND THE TUB
If accidentally an object falls between the drum and
the tub you can recover it thanks to a removable
plastic lifter:
1.
Unplug the appliance.
2.
Remove the laundry from the drum.
3.
Close the drum flaps and turn the drum to the
opposite of the flaps.
4.
Press the plastic tip while sliding the plastic lifter
from left to right.
The plastic lifter will fall into the drum.
5.
Open the drum: through the hole inside the
drum you can recover the object.
6.
Refit the plastic lifter from inside the drum:
Position the plastic tip above the hole on the
right side of the drum.
Then slide the plastic lifter from right to left until
it clips.
7.
Plug in the appliance to the electrical outlet.
This appliance is equipped with safety functions
which detect faults at an early stage and react
appropriately.
Often, however, the faults detected are small
enough to be solved in a matter of minutes.
The appliance will not start, no lamp
lights up.
Check whether:
the appliance is plugged in;
the wall socket is functioning correctly (use a
table lamp or similar).
The appliance will not start, but the
Start lamp is flashing.
Check whether:
the appliance lid is properly closed;
a programme has been selected and the
programme is started.
the water tap is open.
The appliance stops during the
programme.
Check whether:
the Rinse Hold button is flashing, terminate
this option by pressing the button again;
another programme has been selected.
Reselect the desired programme and press the
Start/Pause button;
Start/Pause lamp is flashing. Press Start
button.
the door was opened and the Start/Pause
button is flashing. Press it again.
Safety system of the appliance was activated.
See fault description table on this page.
Detergent and additive product residues
in dispenser at end of wash.
Check whether:
the siphon is correctly installed and clean (see
Maintenance and Cleaning/ Detergent and
Additives);
enough water is being supplied. The mesh
filters could be clogged (see Maintenance and
Cleaning/ Water Hose Mesh Filters).
The appliance vibrates during the spin
cycle.
Check whether:
the appliance is level and solidly installed on all
feet (see Installation instructions);
the transport screws and transport bar have been
removed.
Before starting up the appliance, the transport
screws and the transport bar must be removed
(see Installation Instructions).
Final spin results are poor.
the appliance has an imbalance detection and
correction system. If individual heavy articles are
loaded (bathmat, bathrobe, etc.) this system may
reduce the spin speed automatically to protect
the appliance. It may even interrupt the spin cycle
altogether, if the imbalance is too great after
several spin starts;
if the laundry is too wet at the end of the cycle,
add more articles of laundry to balance the load
and repeat the spin cycle;
excessive foam formation may prevent spinning.
Use less detergent.
Check whether:
the pump impeller is obstructed (see Removing the
Foreign Body Trap) Fault Waterstop.
MAINTENANCE AND CLEANING
TROUBLESHOOTING GUIDE
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bauknecht wate 9573 2 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bauknecht wate 9573 2 in de taal/talen: Nederlands, Engels als bijlage per email.

De handleiding is 0,5 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info