332239
8
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
15
ELECTRICAL CONNECTIONS
Electrical connection must be made before connecting the
appliance to the electricity supply. The appliance must be
installed by a qualified electrician who is fully aware of current
safety and installation regulations. Specifically, installation must be
carried out in compliance with the regulations of the local
electricity supply company. Make sure that the voltage shown on
the rating plate is the same as the power supply voltage in your
home. Regulations require that the appliance be earthed: use
conductors (including the earth conductor) of the appropriate
size only. The manufacturer declines all liability for injury to
persons or animals and for damage to property resulting from
failure to observe the above regulations. For the electrical
connection use a H05RR-F type cable as indicated in the table
below:
Power supply voltage.
The appliance must be connected to the electricity supply by
means of an all-pole disconnect switch with minimum contact
gap of 3 mm.
Attention: the power supply cable must be long enough to allow
the cooktop to be removed from the worktop and must be
positioned so as to avoid damage or overheating caused by
contact with the base.
Connecting to the terminal board
Note: the yellow/green earth wire must be connected to the
terminal with the symbol and must be longer than the other
wires.
Remove approx. 70 mm of the cable sheath from the power
supply cable (B).
Strip approx. 10 mm of sheath from the wires. Then insert the
power supply cable into the cable clamp and connect the
wires to the terminal block as indicated in the connection
diagram placed close to the terminal block itself.
Secure the power supply cable (B) by means of the cable
clamp.
Close the terminal board with the cover (A) securing it with
the screw provided.
After the electrical connection, fit the hob from the top and
hook it to the support springs, according to the illustration.
Conductors Amount x size
230V ~
+
3 X 4 mm
2
230-240V ~ +
3 X 4 mm
2
(Australia only)
230V 3~
+
4 X 1.5 mm
2
400V 3N ~ +
5 X 1.5 mm
2
400V 2N ~ +
4 X 1.5 mm
2
8

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Bauknecht-edps-6640-in

Zoeken resetten

  • Mijn kookplaat werkt alleen aan de linkerkant, alle bedieningsknoppen werken correct, maar de twee kookzones aan de rechterkant blijven koud. Heb het meerdere keren geprobeerd, ze blijven koud. Wat wel apart is, wanneer ik de kookzones uit zet staat er wel de "H" in het display, terwijl de kookzones niet warm geworden zijn. Misschien een zekering defect? Gesteld op 10-9-2020 om 12:59

    Reageer op deze vraag Misbruik melden
  • erro code 22 bij het aanzetten EDPS 6640 IN

    Keramische kookplaat Gesteld op 24-6-2012 om 10:27

    Reageer op deze vraag Misbruik melden
    • Heeft u al een antwoord op uw error code 22?
      Ik heb precies hetzelfde.
      Hoop wat van u te horen.

      Groetjes,
      Joey

      joey.wolters@hotmail.nl Geantwoord op 21-1-2013 om 22:36

      Waardeer dit antwoord Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bauknecht edps 6640 in bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bauknecht edps 6640 in in de taal/talen: Engels als bijlage per email.

De handleiding is 1,98 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Bauknecht edps 6640 in

Bauknecht edps 6640 in Snelstart handleiding - Nederlands - 4 pagina's

Bauknecht edps 6640 in Gebruiksaanwijzing - Nederlands - 8 pagina's

Bauknecht edps 6640 in Gebruiksaanwijzing - Deutsch - 8 pagina's

Bauknecht edps 6640 in Snelstart handleiding - Deutsch - 4 pagina's

Bauknecht edps 6640 in Snelstart handleiding - English - 4 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info