Volume
Press to raise or lower the volume. The
VOLUME control on the front panel turns.
Unpacking
Always switch the power off before changing connections.
Input Selector
Unpack the product fully. The carton should contain
Turn to select the listening source. The 8000S mutes briefly when a
( The Audiolab 8000S integrated amplifier
new input is selected.
( One IEC power cord suitable for your area
Volume Control
( One Remote Handset with two AA batteries
(
Adjusts playing volume. Always turn the volume up gradually.
This instruction manual.
Record Selector
If any item is missing or damaged report this to your dealer as
soon as possible.
Turn to select source to record to Tape 1, Tape 2 or Video. The
Retain the packing for future safe transport of your amplifier. If
connections can also be used to connect to any recorder with
you dispose of the packing, do so with regard to any recycling
analogue inputs such as a CD, MP3, DAT recorder, etc.
regulations in your area.
Record selector and input selector operate independently. It is
Inserting Batteries in the Handset
possible to record from any source whilst listening to another.
Mode Switch
The battery compartment is on the rear of the handset. Unwrap the
Select integrated when using 8000S as an integrated amplifier.
batteries, open the compartment cover and insert the batteries.
Select mute to turn off pre-amplifier outputs, loudspeakers or
Follow the polarity indications in the battery compartment.
headphones. See section 4 for further details.
Always replace batteries in pairs. Use new batteries of the same
Headphone Socket
type and rating, ideally from the same manufacturer.
Socket for connection of headphones. Unplug headphones when
Controls And Functions
not in use. Connecting headphones mutes the loudspeakers and
Power Switch
disconnects the pre-amplifier outputs and power amplifier inputs.
When power is switched on the 8000S is muted for 8 seconds.
2: Introduction
5: Service and Warranty
RECORD
SELECTOR
INPUT
SELECTOR
MODE
SWITCH
VOLUME
CONTROL
HEADPHONE
SOCKET
POWER
SWITCH
POWER LED
RED=Power On
MUTE LED
RED=Mute On
REMOTE
CONTROL SENSOR
Input
Press to select listening source. The INPUT
selector on the front panel turns.
If you wish to record, the record input must be
selected manually.
Mute
Toggles mute On/off. Does not function if the
MODE switch on the front panel is set to mute.
Remote Handset
Buttons shown in white control the 8000S.
Buttons shown in grey operate Audiolab CD
players and have no effect on the 8000S.
As the handset uses RC5 coding it will operate
many other players. Check with your dealer.
Servicing
Servicing of Audiolab products should only be carried out by
authorised service agents. If service is required the equipment
should be returned, securely packaged, preferably using original
packaging, to your dealer.
In the UK equipment may be returned to the IAG Service Centre. In
the USA equipment may be returned to the Service address shown
on this page.
Always telephone before returning any equipment.
A note should be enclosed giving your name, address, telephone
number, and a brief description of the reason for return.
If you require Service outside the Warranty period, do not hesitate
to contact your dealer.
While cleaning is in progress the AC power cord must be
unplugged from the AC power supply socket.
Any grease or dirt on the equipment may be removed with a soft,
lint-free cloth slightly moistened with a mild solution of warm
water and detergent or washing-up liquid. Do not use any other
solutions or solvents.
Retain original packaging for transporting equipment.
If you have any queries regarding the use of Audiolab equipment,
consult your dealer.
Service Addresses, UK & USA
IAG Service Centre
Unit 4
St Margaret’s Way
Stukeley Meadows Industrial Estate
Huntingdon
Cambs
PE29 6EB
England
452561
13403
Tel:+44 (0)1480
Fax: +44 (0)1480
IAG America, Inc.
15 Walpole Park South
Walpole
MA 02081
USA
Tel: +1 508 850 3950
Fax +1 508 850 3905
Audiolab limited warranty
Audiolab or its authorised agents or distributors.
! Products not purchased from an Audiolab authorised dealer.
Audiolab Ltd. warrants this product, subject to the terms and
! Products that were not new at the time of original purchase.
conditions below, to be free from defects in materials and
! Products sold 'as is', 'as seen' or 'with all faults'.
workmanship. During the warranty period Audiolab will repair or
Repairs or replacements as provided under this warranty are the
replace (at Audiolab's option) this product, or any defective part in
this product, if it is found to be defective due to faulty materials,
exclusive remedy of the consumer. Audiolab shall not be liable for
any incidental or consequential damages for breach of any express
workmanship or function. The warranty period may vary from
country to country.
or implied warranty in this product. Except to the extent prohibited
by law, this warranty is exclusive and in lieu of all other warranties
Terms and conditions:
whatsoever, both express and implied, including, but not limited
The warranty starts on the date of purchase (or the date of delivery
to, the warranty of merchantability and fitness for a practical
if this is later).
purpose.
You must provide proof of purchase / delivery before work can be
This warranty provides benefits that are additional to and do not
carried out. Without this proof, any work carried out will be
affect your statutory rights as a consumer.
chargeable to you.
Some countries and US states do not allow the exclusion or
All work will be carried out by Audiolab or its authorised agents or
limitation of incidental or consequential damages or implied
distributors. Any unauthorised repair or modification will void this
warranties so the exclusions in the paragraph above may not
warranty.
apply to you. This warranty gives you specific legal rights, and you
If any part is no longer available it will replaced with a functional
may have other statutory rights, which vary from state to state or
replacement part.
country to country.
Any parts that are replaced will become the property of Audiolab.
How to claim:
Any repair or replacement under this warranty will not extend the
To obtain warranty service contact the Audiolab authorised dealer
period of warranty.
from which you purchased this product. Do not despatch goods
This warranty is valid only in the country of purchase, applies only to
without the prior agreement of the dealer, Audiolab or their
the first purchaser and is not transferable.
authorised distributors.
The following are not covered:
If asked to return products for inspection and/or repair, pack
! Products on which the serial number has been removed,
carefully, preferably in the original cartons or packaging affording
altered or otherwise made illegible.
an equal degree of protection, and return prepaid. If unsuitable
! Normal wear and tear and cosmetic damage.
packaging is used, Audiolab may make a charge for the supply of
! Transportation or installation of the product.
new packaging.
! Accidental damage, faults caused by commercial use, acts of
Insurance is recommended as goods are returned at owner's risk.
God, incorrect installation, connection or packaging, misuse,
Audiolab or their authorised distributors cannot be held liable for
neglect or careless operation or handling of the product which
loss or damage in transit.
is not in accordance with Audiolab's user instructions.
Packing, insurance and freight on the return journey will be paid by
! Equipment that has been operated in conjunction with
Audiolab or their authorised agents or distributor if corrective work
unsuitable, inappropriate or faulty apparatus.
! Repairs or alterations carried out by parties other than
proves to be necessary.
