9
2/
Unlocking the panel heater’s hanging frame
We recommend that you place the panel heater face down on the floor
.
-
Take a flat-bladed screwdriver and lift the slider, taking care not to bend it
.
-
While keeping the sli-der raised, push the hanging frame towards the bottom of the heater to release the upper
brackets S2. We recommend that you wear protective gloves.
-
Swivel the hanging frame downwards on the lower brackets S1.
.
-
Remove the hanging frame.
.
3/
Fixing the hanging frame to the wall
-
Place the hanging frame on the floor against the wall. Locate drilling points A.
❼
-
Refit the hanging frame, lining up with drilling points A to find drilling points B (you can also use a level)
❽.
-
Drill the 4 holes and insert the wall plugs. Use suitable wall plugs when fitting on a specific support (e.g. plaster-
board wall).
-
Position the hanging frame and screw it down.
4/
Connecting the panel heater
Connection rules and regulations
- The panel heater must be supplied with 230V single-phase current at 50Hz.
- The panel heater’s power supply must be directly connected to the main supply after the circuit breaker without
any intermediate switch.
- Panel heaters equipped with a socket can be connected to a wall socket.
- The panel heater’s power cable must be connected to the main supply via a connection box. In damp areas, such
as bathrooms and kitchens, the connection box must be installed at least 25cm above the floor.
- An Earth connection is prohibited. Do not connect the pilot wire (black wire) to Earth.
- The installation must be fitted with an all-pole cut-off switch with a contact opening distance of at least 3mm.
- If the power cable is damaged, it must only be replaced by an electrician.
- If you are using the pilot wire and it is protected by a 30mA differential (e.g.: bathroom use), the pilot wire’s power
supply must also be protected on this differential.
Wiring diagram for the heating panel
- Cut off the power supply and connect the wires as
shown in the following diagram:
- You can connect the pilot wire if your home is equip-
ped with a programming unit or controller.
In this case, make the following checks according
the selected mode (Comfort, Eco, etc.) to that the
programming instructions are being transmitted
correctly:
