19
Enter the “Motion Detection” screen from MAIN MENU →ADVANCED, as shown below:
MD CHANNEL and STATUS: Each channel has an independent status. Press Enter to
select motion detection On or Off.
SENSITIVITY: Each channel has a corresponding sensitivity setting, with the four
levels of 1, 2, 3 and 4, where 4 the is the most sensitive.
MD AREA: Each channel has a corresponding motion detection area setting. Move the
cursor to Setup of the corresponding channel, and press Enter to enter the motion
area setup screen of this channel. A red block indicates motion detection is
activated for this area and a transparent block indicates motion detection is not
activated, as shown below:
Operating Prompt:
Remote controller operation: Use (display mode) to select full screen or blank.
Mouse operation: Left-click the mouse and drag the motion box to set the area of
dynamic detection. Right-click when finished to return to the previous screen.
Motion Detection Setup Procedures:
and click SCHEDULE to enter the “ Record Schedule Configuration” and set
the corresponding time to alarm recording (See timed recording in Recording
Mode for the setup method).
After the setup has been c o m p l e t e d and motion is detection triggered, a red
letter M will appear in the screen of this channel. See Alarm Processes in Section
3.6.1 for alarm setup.
