539645
82
Verklein
Vergroot
Pagina terug
1/84
Pagina verder
82
AFTER OPERATION WITH WATER FILTER
60BAfter operation with „water filter unit” it is necessary to perform proper activities in order to clean
inner elements of the tank and prepare it for storage.
Switch the vacuum cleaner off and unplug it.
Remove the hose ending.
Black surface remove the water filter unit from the vacuum cleaner.
Remove the inner module from the tank.
Press the flexible hook of the separator frame with your finger, disassemble the water separator and
remove initial filter.
If it is necessary, remove the node, flush it and assemble again, taking care for proper assembling.
Water filter unit - clean tank, separator and initial filter under running water. Clean the parts
thoroughly.
Dry after cleaning. You can do it in two different ways:
1. Disassemble the parts and leave them until they get dry. Assemble
after drying and insert complete tank into the vacuum cleaner.
2. Assemble complete vacuum cleaner after cleaning (without water) and
switch it on for about 5 min. (Drying with airflow).
ATTENTION!!! Leaving not completely dried parts inside the assembled
vacuum cleaner can cause unpleasant smell.
In case of incidental getting the accessories wet (tubes, hose or nozzles inside)
you should stop the vacuuming switch the vacuum cleaner off and dry the wet
parts.
In order to do it, please set the air recirculation module knob in blowing position and switch the
vacuum cleaner on for about 2 min. The activity is performed to dry the hose, pipes and other
accessories in contact with water. It prevents bacteria development during storage.
FILTERS CONTROL
The vacuum cleaner is equipped with the following filters:
1. Separator and initial filter
Activities connected with cleaning are described in part concerning after
operation activities.
Washing of these parts shall be held after each vacuuming.
Assemble the parts In reverse sequence to disassembling
Be careful during assembling initial filter, so that black surface of the filter
was outside (up).
2. Final filter (HEPA filter for type 819.*.***S)
Final filter removing
Remove the back tank from the housing and turn the vacuum cleaner
so that it was supported with upper, inclined surface and the handle
on the floor.
Move the cursor into such position, that
the open mark was visible.
Open the filter lid according to the figure
beside.
Catch the fin to remove the final filter.
Black
surface
O
p
e
n
Black
surface
82

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Zelmer 819 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Zelmer 819 in de taal/talen: Engels, Pools als bijlage per email.

De handleiding is 6,82 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info